Publicidad
etc.).
- Use the appliance only for dry
working tasks.
- Never leave the appliance
connected and unattended if is
not in use. This saves energy and
prolongs the life of the appliance.
- Do not use the appliance on any
part of the body of a person or
animal.
Service:
- WARNING: There is a risk of
fire if the appliance is not clea-
ned following these instructions.
- Any misuse or failure to fo-
llow the instructions for use
renders the guarantee and the
manufacturer's liability null and
void.
Instructions for use
Before use:
- Remove the appliance's protective film.
- Make sure that all the product's packaging has been
removed.
- Prepare the appliance according to the function you
wish to use.
Vacuuming function:
- Fit the hose unit to the vacuum cleaner's air intake.
- To disconnect the hose unit from the vacuum cleaner,
press the two buttons on the hose joint at the same time
and pull outwards (Fig. 1).
Insertion of accessories into the appliance's grip:
- The appliance's grip is designed in such a way that it
allows the insertion of the following accessories: (use
the combination that best meets your requirements)
- Extendable extension tube: Designed to provide access
to surfaces which are out of reach and make floor
cleaning comfortable, its length can be adjusted by using
the adjustment control.
- Lid: Specially designed for cleaning floors (both rugs,
carpets and hard floors), its base has a retractable brush
that can be adjusted to two heights for greater efficiency
on these floors.
- Lance: Specially designed for getting into cracks and
difficult corners.
- Upholstery brush: Especially suitable for cleaning
textile surfaces.
Use:
Manual Exeo.indb 14
- Take the length of cable required out of the housing.
- Connect the appliance to the mains.
- Turn the appliance on using the on/off switch.
Once you have finished using the appliance:
- Turn the appliance off, using the on/off switch.
- Unplug the appliance to the mains.
- Retract the cable by pressing the roller cable button
and guide the cable into the appliance.
- Clean the appliance
Cord housing
- This appliance has a cable compartment situated on its
posterior.
Carry handle/s:
- The device has a handle on the upper part so it can be
transported easily and comfortably.
Parking position:
- This appliance has one parking position for comfortable
and straightforward storage.
- To use the horizontal parking position, fix the break
pad hook to the hook situated on the rear side of the
appliance (Fig. 2)
Safety thermal protector:
- The appliance has a safety device, which protects the
appliance from overheating.
- If the appliance turns itself off and does not switch
itself on again, disconnect it from the mains supply, and
wait for approximately 45 minutes before reconnecting.
If the machine does not start again seek authorised tech-
nical assistance.
Cleaning
- Disconnect the appliance from the mains and let it cool
before undertaking any cleaning task.
- Clean the equipment with a damp cloth with a few
drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or base
pH such as bleach, or abrasive products, for cleaning the
appliance.
- Do not submerge the appliance in water or any other
liquid, or place it under a running tap.
Emptying the dust box:
- Empty the vacuum deposit when dust is visible though
the transparent walls, when it is full, or when the va-
cuum cleaner does not work to its full potential.
- In all cases, empty the deposit when the deposit full
indicator shows completely red.
- Disconnect the hose from the vacuum cleaner's air
intake. (Fig 3)
- Disconnect the dust box from the appliance. (Fig. 4)
- Open the lid of the dust box and empty the contents into
the appropriate waste disposal receptacle.
- Close the lid of the dust box.
- Attach the dust box to the appliance.
- Connect the hose to the vacuum cleaner's air intake.
Changing the filters:
- Motor filter, it is advisable to be changed at least once a
year or every 100 hours of the appliance's use.
- HEPA air vent filter (High efficiency air filter that
efficiently retains spores, ash, sawdust, pollen...), it is
advisable to change it a least once a year or after every
100 hours of use.
- To remove filters:
23/11/12 18:51
Publicidad
