Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning
the Air Filter
Clean and re-oil the air filter every 10 hours of operation.
It is an important item to maintain. Not maintaining the
air filter will VOID the warranty.
1. Remove air filter/muffler cover. See Removing the
Air filter/Muffler Cover in the Maintenance
section,
2.
Remove the air filter from behind the air filter/muffler
cover (Fig. 14).
3.
Wash the filter in detergent and water (Fig. 15). Rinse
the filter thoroughly. Squeeze out excess water. Allow
it to dry completely.
4.
Apply enough clean SAE 30 oil to lightly coat the
filter (Fig. 16).
5.
Squeeze the filter to spread and remove excess oil (Fig. 17).
6.
Replace the air filter in the air filter/muffler cover tFig. 14).
NOTE: Operating the unit without the air filter and air
filter/muffler
cover assembly, will VOID the warranty.
Reinstalling the Air filter/Muffler
Cover
1. Place the air filter/muffler
cover over the back of the
carburetor and muffler.
NOTE: The choke lever must be in the PARTIAL choke
position (B) (Fig. 13) to install the air filter/muffler cover.
2.
Insert the four {4) screws into the holes in the air
filter/muffler
cover (Fig. 13) ant tighten. Do nol
over tighten.
TO REPLACE
SPARK
PLUG
Use a Champion RDJ7Y spark plug (or equivalent). Correct
a=rgap is 0,020 in, (0,50 mm), Remove plug after every 25
hours of operation and check its condition (Fig. 18).
1.
Stop the engine and pull the wire off of the spark plug.
2.
Clean around the spark plug and remove it from the
cylinder head.
NOTE: Replace a cracked, fouled or dirty spark plug. Do
not sand blast, scrape or clean electrodes because the
engine could be damaged by grit entering the cylinder.
3.
Set the air gap at 0.020 in. (0.50 ram) using a wire
feeler gauge (Fig. 18). nstall a correctly gapped
spark plug into the cylinder head. Torque to
110-120 inolb (12.3-13,5 Nom).
4.
Replace the spark plug w=re.
Air Filter
Fig. 14
Fig. 15
Fig. 16
Fig. 17
0.020
.mj "
Fig. 18
-15-
Publicidad
