Publicidad
Idiomas disponibles
Idiomas disponibles
CARTON
CONTENTS
• Trimmer
• Hardware Pack
TOOLS
REQUIRED
FOR ASSEMBLY
• Large Phillips Screwdriver
ASSEMBLY
INFORMATION
To ensure safe and proper operation of your unit, all
parts and hardware you assemble must be tightened
securely.
TO ASSEMBLE
AND ADJUST
ASSIST
HANDLE
1. Place the assist handle between the top and middle
clamp pieces (Fig. 1).
2.
While holding these three pieces together, install the four
(4) screws through the top clamp and into middle clamp.
NOTE: The holes in the top and middle clamp will line
up only when assembled correctly.
3.
Place the clamps and assist handle over the shaft
housing and onto the bottom clamp.
4.
Hold each hex nut in the bottom clamp recess with a
finger. Start the screws with a large Phillips screwdriver.
Do not tighten until you make the handle adjustment.
Assist Handle
5.
Slide the assist handle in or out until the arrow/white
line
on the decal touches the c!am p assembly (Fig, 2).
6, While holding the unit in the operating position (Fig. 3),
position the assist handle to the location that provides
you the best grip:
7. Tighten the clamp screws evenly, until assist handle
is secure.
Decal
/
Fig. 2
Shaft Housing
-,
Fig. 1
Middle Handle
C,amp
J Bottom Handle
Clamp
Nuts
Fig. 3
-8-
Publicidad
