Craftsman WEEDWACKER 316.74556 Manual Del Operador página 9

INSTALLING THECUTTING ATTACHMENT SHIELD Cutting
Attachment Shield
Use the following instructions if the cutting attachment
shield on your unit is not installed.
_b ARNING: Never operate the trimmer without
the cutting attachment shield in place to
prevent serious personal injury.
1. Slide the cutting attachment shield into the shield
mount on the cutting attachment. Align the screw holes
in the shield with the holes in the shield mount (Fig. 4).
2. Place a hex lock nut into one of the three recessed
holes on the top of the cutting attachment shield (Fig 5).
3. Install a screw into the hole from the bottom of the
cutting attachment shield and screw it into the nut
installed in step #2 (Fig 6). Do not tighten.
4. Repeat steps 2 and 3 until all three screws have
been started, then tighten screws securely with an
appropriate screwdriver.
Shield Mount
Cutting Attachment
Fig. 4
(3) Hex Lock Nuts
Top of Lock
Nut
Fig. 5
(3)
Fig. 6
_lndents
-9-