Craftsman WEEDWACKER 316.74556 Manual Del Operador página 4

•
Be sure the cutting attachment is not in contact with
anything 3efore starting the unit.
• The cutting attachment shield must always be in place
while operating the unit as a tnmmer. Do not operate
unit without both trimming lines extended, and the
proper line installed. Do not extend the trimming line
beyond the length of the shield.
• This unit has a clutch. The cutting attachment will not
rotate when the engine is idling. Engine adjustments
should be done by any nonroad engine repair
establishment, individual or authorized service deale_
• Use the unit only in daylight or good artificial light.
• Avoid accidental starting. Be in the starting position
whenever pulling the starter rooe. The operator ant
unit must be in a stable position while starting. See
Stopping/Starting InstracUons in the Operation
section.
• Use the right tool for the job, and use this tool only for
the purpose intended.
• Do not overreach. Always keep proper footing and
balance.
• Always hold the unit with both hands when operating.
Keep a firm grip on both the front and rear handle or grips.
• Keep hands, face and feet at a distance from all
moving parts. Do not touch or try to stop the cutting
attachment when it is rotating.
• Do not touch the engine or muffler. These parts get
extremely hot from operation. When turned off they
remain hot for a short time.
• Do not operate the engine faster than the speed
needed to cut. trim or edge. Do not run the engine at
high speed when not cutting.
• Always stop the engine when cutting is delayed or
when walking from one cutting location to another.
• If you strike or become entangled with a foreign
object, stop the engine immediately and check for
damage. Do not operate before repairing damage. Do
not operate the unit with loose or damaged parts.
• Stop and switch the engine to off for maintenance,
repair, or for changing the cutting attachment or other
attachments.
• Use only genuine Craftsman® replacement parts when
servicing this unit. These parts are available from your
authorized service dealer. Do not use parts, accessories
or attachments not authorized by Craftsman for this
unit. Doing so could lead to serious injury to the user, or
damage to the unit, and void your warranty.
• Keep unit clean of vegetation and other materials.
They may become lodged between the cutting
attachment and shield.
• To reduce fire hazard, replace faulty muffler and spark
arrestor, keep the engine and muffler free from grass,
leaves, excessive grease or carbon build up.
OTHER SAFETY WARNINGS
• Never store the unit, with fuel in the tank, inside a
building where fumes may reach an open flame or spark.
• Allow the engine to cool before storing or transporting.
B e sure to secure th e unit while transporting.
• Store the unit in a locked up and dry, or high and dry
place to prevent unauthorized use or damage, Keep
out of the reach of children.
• Never douse or squirt the unit with water or any other
liquid. Keep handles dry, clean and free from debds. Clean
after each use. See the Maintenance and Storage
sections.
• Keep these instructions. Refer to them often and use
them to instruct other users. If you loan someone this
unit, also loan them these instructions.
SAVE THESE INSTRUCTIONS
-4-