Publicidad
Idiomas disponibles
Idiomas disponibles
TO START
ENGINE
When
starting
the engine for the first time
or if the engine
has run out of fuel, it will
take extra cranking
time to move fuel from
the tank to the engine.
I_ Be sure freewheel
control is in the
transmission
engaged
position,
2.
Sit on seat in operating
position,
depress
clutch/brake
pedal and set
parking
brake.
3.
Place motion
control lever in neutral
(N) position°
4.
Move attachment
clutch to disengaged
position.
5.
Move throttle
control
to fast position
6o Pull choke control out for a cold engine
start attempt.
For a warm engine
start
attempt
the choke control
may not be
needed.
NOTE:
Before starting,
read the warm and
cold starting
procedures
below,
7.
Insert key into ignition
and turn key
clockwise
to start position
and release
key as soon as engine starts.
Do
not run starter
continuously
for more
than fifteen seconds
per minute.
If the
engine does not start after several
attempts,
push choke control
in, wait
a few minutes
and try again.
If engine
still does not start, pull the choke con-
trol out and retry.
WARM WEATHER
STARTING
(50 ° F and
above)
8. When
engine starts,
slowly push choke
control
in until the engine begins
to
run smoothly.
If the engine starts to
run roughly,
pull the choke control out
slightly
for a few seconds
and then
continue
to push the control
in slowly.
• The attachments
and ground drive can
now be use&
If the engine does not
accept
the load, restart
the engine
and
allow it to warm up for one minute using
the choke as described
above.
COLD WEATHER
STARTING
(50 ° F and
below)
8. When engine starts,
slowly push choke
control
in until the engine begins to run
smoothly.
Continue
to push the choke
control
in small steps allowing
the en-
gine to accept
small changes
in speed
and toad, until the choke control
is fully
in. if the engine starts to run roughly,
pull the choke control out slightly
for a
few seconds
and tllen continue
to push
the control
in slowly. This may require
an engine warm-up
period from several
seconds
to several
minutes,
depending
on the temperature.
AUTOMATIC
TRANSMISSION
WARM
UP
Before driving
the unit in cold weather,
the transmission
should
be warmed
up as
follows:
1.
Be sure the tractor
is on level ground_
2o Place the motion control
lever in
neutral° Release
the parking
brake and
let the clutchlbrake
slowly return
to
operating
position,
3o Allow one minute for transrnission
to
warm up. This can be done during the
engine warm up period.
• The attachments
can be used during
the engine warm-up
period
after the
transmission
has been warmed
up and
may require the choke control be pulled
out slightly.
NOTE:
If at a high altitude
(above 3000
feet) or in cold temperatures
(below 32 F)
the carburetor
fuel mixture
may need to
be adjusted
for best engine
performance
(see "TO ADJUST
CARBURETOR"
in the
Service
and Adjustments
section
of this
manual)_
PURGE
TRANSMISSION
_,CAUTION:
Never engage
or dis-
engage
freewheel
lever while the engine
is running.
To ensure
proper operation
and per-
formance,
it is recommended
that the
transmission
be purged
before operating
tractor for the first time. This procedure
will
remove
any trapped
air inside the trans-
mission
which may have developed
during
shipping
of your tractor.
IMPORTANT:
Should your transmission
require removal
for service
or replace-
ment, it should
be purged after reinstall-
ation before operating
the tractor.
I.
Place tractor safely on a level surface
- that is clear of objects
and open - with
engine off and parking
brake set.
2.
Disengage
transmission
by placing
freewheel
control
in disengaged
posi-
tion (See "TO TRANSPORT"
in this
section
of manual)°
3o Sitting in the tractor
seat, start engine.
After the engine
is running,
move
throttle
control to slow position.
With
motion control lever in neutral
(N)
position,
slowly disengage
clutch/brake
_Pced
alo
AUTION:
At any time, during step
4, there may be movement
of the drive
wheels.
14
Publicidad
