Descargar Imprimir esta página

Husqvarna LOGTH2448T Manual De Instrucciones página 28

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
CHART:
See appropriate
section
in manual
unless
directed
to a service
center
PROBLEM
Will not start
Hard to start
Engine will not
turn over
Engine clicks but
will not start
CAUSE
1. Out of fuel.
2.
Engine not "CHOKED"
properly.
3.
Engine flooded.
Loss of power
4.
Bad spark plug.
5. Weak or dead battery°
6.
Dirty air filter.
7.
Dirty fuel filter.
8. Water in fuel.
9.
Loose or damaged
wiring.
t0. Carburetor
out of adjustment.
11, Engine valves out of
adjustment,
1.
Dirty air filter.
2_ Bad spark plugo
3_ Weak or dead battery.
4.
Dirty fuel filter.
5o Stale or dirty fuel.
6_ Loose or damaged
wiring.
7.
Carburetor
out of adjustment.
8,
Engine valves out of
adjustment,
1. Brake pedal not depressed.
2. Attachment
clutch is engaged.
3.
Weak or dead battery.
4.
Blown fuse.
5,
Corroded
battery
terminals.
6.
Loose or damaged
wiring.
7.
Faulty ignition
switch.
8.
Faulty solenoid
or starter.
Faulty operator
presence
switch(es).
1o Weak or dead battery.
2. Corroded
battery
terminals,
3.
Loose or damaged
wiring.
4.
Faulty solenoid
or starter.
1, Cutting
too much grass/too
fast.
2o Throttle
in "CHOKE"
position,
3. Build-up
of grass, leaves and
trash under mower,
. Dirty air filter.
. Low oil level/dirty
clio
CORRECTION
1. Fill fuel tank.
2.
See "TO START ENGINE"
in
Operation
section.
3. Wait several minutes
before
attempting
to start.
4.
Replace
spark plug.
5o Recharge
or replace
battery.
6
Clean/replace
air filter.
7.
Replace
fuel filter.
8.
Empty fuel tank and carbure-
tor, refill tank with fresh gas-
oline and replace
luel filter.
9.
Check all wiring.
t0. See "To Adjust Ca rbu retor"
in Service
and Adjustments
section.
11. Contact
a qualified
service
center.
1. Clean/replace
air filter.
2.
Replace
spark plugo
3_ Recharge
or replace
battery.
4.
Replace
fuel filter.
5. Empty fuel tank and refill tank
with fresh, clean gasoline,
6.
Check all wiring.
7o See "To Adjust Carburetor"
in
Service
and Adjustments
section.
8,
Contact
a qualified
service
center,
1. Depress
brake pedal.
2.
Disengage
attachment
clutch,
3.
Recharge
or replace
battery,,
4o Replace
fuse.
5.
Clean battery
terminals.
6.
Check all wiring.
7_ Check/replace
ignition switch,
8.
Check/replace
solenoid
or
starter.
9. Contact
a qualified
service
center,
1.
Recharge
or replace
battery,
2.
Clean battery
terminals.
3.
Check all wiring_
4,
ChecWreplace
solenoid
or
starter.
4_
5.
Raise cutting
height/reduce
speed.
Adjust throttle control,
Clean underside
of mower
housing.
Clean/replace
air filter.
Check oil level/change
oil,
28

Publicidad

loading