Publicidad
Idiomas disponibles
Idiomas disponibles
__-@
TO CHECK
BRAKE
if tractor
requires
more than five (5) feet to
stop at highest
speed in highest
gear on a
level, dry concrete
or paved surface,
then
brake must be serviced.
You may also check brake by:
1. Park tractor
on a level, dry concrete
or
paved surface,
depress
brake pedal
all the way down and engage
parking
brake.
2_ Disengage
transmission
by placing
freewheel
control in "transmission
dis-
engaged"
position.
Pull freewheel
con-
trol out and into the slot and release
so
it is held in the disengaged
position.
The rear wheels must lock and skid
when you try to manually
push the tractor
forward° If the rear wheels
rotate, then the
brake needs to be serviced.
Contact
a
qualified
service
center°
TO REMOVE
WHEEL
FOR REPAIRS
1. Block up axle securely.
2.
Remove
axle cover, retaining
ring and
washers
to allow wheel
removal
(rear
wheels
have a square
key - Do not
Iose)_
3_ Repair tire and reassemble.
NOTE:
On rear wheels only:
align
grooves
in rear wheel
hub and axle.
Insert
square
key.
4.
Replace
washers
and snap retaining
ring securely
in axle groove°
5.
Replace
axle cover.
NOTE: To seal tire punctures
and prevent
flat tires due to slow leaks,
purchase
and
use tire sealant.
Tire sealant also prevents
tire dry rot and corrosion.
Washers
Retaining
Ring
Axle
Cover
|
Square Key (Rear_
Wheel Only)
TO START
ENGINE
WITH A WEAK
BAT-
TERY
,__WARNING:
Lead-acid
batteries
gen-
erate explosive
gases.
Keep sparks, flame
and smoking
materials
away from bat-
teries.
Always
wear eye protection
when
around
batteries°
tf your battery
is too weak to start the
engine,
it should
be recharged.
(See "BAT-
TERY" in the MAINTENANCE
section
of
this manual)°
If "jumper cables"
are used for emergency
starting,
follow this procedure:
IMPORTANT:
Your tractor
is equipped
with a 12 volt system_The
other vehicle
must also be a 12 volt system.
Do not use
your tractor
battery
to start otl_er vehicles°
TO ATTACH JUMPER
CABLES
-
1. Connect
one end of the RED cable
to the POSITIVE
(+) terminal
of each
battery(A-B),
taking care not to short
against
tractor chassis.
2.
Connect
one end of the BLACK
cable
to the NEGATIVE
(-) terminal
(C) of
fully charged
battery.
3.
Connect
the other end of the BLACK
cable (D) to good chassis
ground,
away from fuel tank and battery_
TO REMOVE
CABLES,
REVERSE
ORDER
-
I_ BLACK cable first from chassis and
then from the fully charged
battery.
2.
RED cable last from both batteries.
Weak or Dead Battery
Fully Charged Battery
25
Publicidad
