MTD 300 Serie Manual De Instrucciones página 11

ShavePlate
The shave plate maintains contact with pavement as the snow
thrower is propelled, allowing snow close to pavement's surface
to be discharged.
SkidShoes
Position the skid shoes based on surface conditions. Adjust
upward for hard-packed snow. Adjust downward when
operating on gravel or crushed rock surfaces.
ChuteAssembly
Snow drawn into the auger housing is discharged out the chute
assembly.
ChuteClean-OutTool
WARNING! Never use your hands to clear a
clogged chute assembly. Shut off engine and remain
behind handles until all moving parts have stopped
before unclogging.
The chute clean-out tool is conveniently fastened to the rear of
the auger housing with a mounting clip. Should snow and ice
become lodged in the chute assembly during operation, proceed
as follows to safely clean the chute assembly and chute opening:
1. Release both the Auger Control and the Drive Control.
2. Shut off engine as instructed in the engine manual.
3. Remove the clean-out tool from the clip which secures it to
the rear of the auger housing.
4. Use the shovel-shaped end of the clean-out tool to
dislodge and scoop any snow and ice which has formed in
and near the chute assembly.
5. Refasten the clean-out tool to the mounting clip on the
rear of the auger housing, start the snow thrower's engine
as instructed in the engine manual.
While standing in the operator's position (behind the snow
thrower), engage the auger control for a few seconds to clear any
remaining snow and ice from the chute assembly.
SECTION 4 -- CONTROLS AND FEATURES
11