MTD 300 Serie Manual De Instrucciones página 17

Troubleshooting
Problem Cause Remedy
Unit fails to self-propel
Unit fails to discharge snow
1. Drive belt loose or damaged.
2. Single speed transmission damaged.
1. Chute assembly clogged.
2. Shear pin(s) sheared.
3. Foreign object lodged in auger.
4. Auger control cable out of adjustment.
5. Auger belt loose or damaged.
1. Replace drive belt.
2. See an Authorized Service Dealer.
1. Stop engine and disconnect spark plug wire.
Clean chute and inside of auger housing with
clean-out tool or stick.
2. Replace shear pin(s).
3. Stop engine immediately and disconnect the
spark plug wire. Remove object from auger.
4. Adjust auger control cable.
5. Replace auger belt.
IMPORTANT:
Refer to the engine operator's manual included with the snow thrower for engine troubleshooting instructions.
NOTE: For repairs beyond the minor adjustments listed above, contact your nearest authorized service representative or ca II 1-800-800-7310
for the Customer Support Center. Refer to the engine manual packed separately with your snow thrower, for complete engine related
information.
17