AMSTRAD SRX 350 Manual De Instrucciones página 33

[ 4 CUSTOMISATION
* Skip this section unless you want to change the factory-set values (shown on accompanying
Satellite Check Chart).
AUDIO MODE CUSTOMISATION
To change audio mode subcarrier frequencies, follow these instructions:
@ Press SET-UP repeatedly until you see picture similar to:
@ As before, adjust flashing setting using SELECT + or -,
confirm setting using OK, and finish using EXIT.
NOTES
- MO or ST sets mono or stereo.
- 5.50 to 8.50 selects audio subcarrier frequency (in MHz).
- For stereo modes, L and R denote left and right channels. (Note the right channel frequency automatically
tracks the left by +0.18MHz.)
- |NARROW or WIDE sets audio bandwidth (mono modes only).
- | To abandon customisation at any point, press STANDBY.
FURTHER INFORMATION - SECTION I5H
INSTALLATION CUSTOMISATION
To change installation settings, follow these instructions:
@ Press SET-UP repeatedly until you see picture similar to:
@ As before, adjust flashing setting using SELECT + or -,
confirm setting using OK, and finish using EXIT.
NOTES
- LNB A,LOW selects frequency of low local oscillator for
currently selected LNB. (If LNB Bis currently selected then
above display will be LNB B,LOW.)
- LNB A,HIGH selects frequency of high local oscillator for currently selected LNB (dependent on LNB
fitted). Note HIGH option will enable future reception of an extra band of Astra channels (scheduled
introduction from 1994).
- FINE TUNE A,LOW and FINE TUNE A,HIGH fine-tune the low and high local oscillators for currently
selected LNB (dependent on LNB fitted).
- TVISAT selects whether your currently selected TV channel is automatically overridden by satellite channel
when receiver is switched on (only applicable if your TV is connected to receiver's TV SCART/PERITEL
socket).
- LANGUAGE sets language for all on-screen displays.
- To abandon customisation at any point, press STANDBY.
FURTHER INFORMATION - SECTION 15]
GB - 12