Publicidad
Idiomas disponibles
Idiomas disponibles
CIRCLE
CUTTING
1. Before attaching
the rip fence, draw a circle
and drive a finishing nail in the center of circle.
2. Drill or plunge cut near the circles edge,
turn saw off and disconnect
the plug from
power source (Fig. 17).
3. Attach rip fence to saw with the edge guide
facing UP.
4. Place the metal center point on the edge
guide into the hole in the center of the circle.
In order for the edge guide to cut a circle, the
metal center point MUST BE in alignment
with
saw blade (see Fig. 18).
5. Measure the distance from the selected
hole to the bIade to be equal to the circle
radius.
6. Insert plug into power source, hold the saw
firmly, squeeze trigger and slowly push the
saw forward. To make a hole, cut from inside
the circle; To make wheels or discs, cut from
the outside.
Cutting Tip: Cut slowly so the blade will stay
straight in the cut. Place small wedges
in the
cut as shown in Fig. 17, to keep the inner
circle from spreading when near the end of
the cut.
(
\
J
EDGE
"WEDGE
GUIDE UP
BLADE MUST BE IN ALIGNMENT
WITH METAL CENTER POINT
-14-
Publicidad
