Publicidad
Idiomas disponibles
Idiomas disponibles
+a_
i6!9X0<427
9-G4
9/23/04
9 ;04 _i,__ P
8
Attaching the Blade
To prevent personal injury,
always disconnect
plug from
power source before assembling
parts, making
adjustments,
or changing blades.
1, Insert the saw blade (teeth in cutting
direction)
until it latches in the plunger
(Fig. 2).
TOOL-LESS
COVER
When inserting
the saw blade, the back of
the blade must rest in the groove of the
guide roller (Fig, 3).
2. To remove blade, lift tool-less blade change
cover up with index finger and thumb and
remove blade.
For use with both T or U shank sabre saw
blades.
BLADE---+
GU DE ROLLER
--
f
...........................
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed trigger
switch, The tool can be turned 'rON" or "OFF" by
squeezing or releasing the trigger. The speed
can be adjusted from the minimum to maximum
nameplate SPM by the pressure you apply to the
trigger. Apply more pressure to increase the
speed and release pressure to decrease speed
(Fig. 1).
"LOCK-ON"
BUTTON
The "Lock-ON"
button, located in the handle of
your tool allows Ior continuous operation
at
maximum
SPM without holding the trigger
(Fig. 1).
TO LOCK TRIGGER
"ON": squeeze
trigger,
depress button and release trigger.
TO UNLOCK THE TRIGGER:
squeeze trigger
and release it without depressing
the "Lock-
ON" button.
lf the "Lock-ON" button is
continuously being depressed,
the trigger can not be released.
PLUNGER
SPEED
The stroke rate may be adjusted as described
earlier under "Variable Speed Controlled
Trigger Switch". The best results for a particular
application
are determined
by experience,
though as a general rule, slower speeds are for
denser materials and faster speeds are for soft
materials.
LASER LIGHT/WORKLIGHT
CONTROL
WHEEL
_
ASER RADIATION,
AVOID
DIRECT EYE EXPOSURE.
DO NOT stare into the laser light source.
Never aim light at another person or object
other than the workpiece.
Laser light can
damage your eyes.
DO NOT use tinted
glasses
to enhance
the laser light,
Tinted glasses will reduce overall vision for
the application
and interfere with the normal
operation of the tool.
_
Never aim the beam at a
workpiece
with a reflective
surface.
Bright shiny reflective sheet steel or
similar reflective surfaces are not
recommended
for laser use. Reflective
surfaces
could direct the beam back toward
the operator,
Use of controls or
adjustments
or performance
of procedures
other than those specified
herein may result in hazardous
radiation
exposure.
The use of optical
instruments
with this product
will increase
eye hazards.
-8-
÷
÷
Publicidad
