Publicidad
Idiomas disponibles
Idiomas disponibles
Generac Portable Products 3000 PSI P ressure Washer
PREPARING
THE
UNIT
FOR STORAGE
Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump parts and
"freeze" pump action. If you do not plan to use the
pressure washer for more than 30 days,follow this
procedure:
I.
Flush detergent siphoning tube by placing the filter into
a pail of clean water while running pressure washer in
low pressure mode. Flush for one to two minutes.
2.
Shut off the engine and let it cool, then remove all
hoses. Disconnect spark plug wire from spark plug.
3.
Empty the pump of all pumped liquids by pulling the
recoil handle about 6 times. This should remove most
of the liquid in the pump.
4.
Use Generac brand pump saver to prevent corrosion
build up and freezing of pump.
5.
Store unit in a clean, dry area.
Protecting
the Pump
To protect the pump from damagecaused by mineral
deposits or freezing, use the Generac PumpSaverto treat
pump. This prevents freeze damage and lubricates pistons
and seals.
NOTE: Generac PumpSaver is availableas an optional
accessory.It is not includedwith the pressure washer.
CAUTION!
You must protect your unit from freezing
temperatures. Failure to do so will permanently damage
your pump and render your unit inoperable. Freeze damage
is not covered under warranty.
_
CAUTION!
Read and follow all cautions and
warningson the PumpSavercan label.Always wear
eye protection when using PumpSaver.
To use PumpSaver, make sure the pressure washer is
turned off and disconnected
from supply water. Read and
follow all instructions
and warnings given on the PumpSaver
container.
NOTE: PumpSaverwill drip from pump after treatment
and will stain wood and concrete.
NOTE: If PumpSaveris not available, draw RV antifreeze
(non-alcohol) into the pump by pouring the solution into a
3-foot section of garden hose connected to inlet adapter
and pulling recoil handle twice.
STORING
THE
ENGINE
See the engine owner's manual for instructions on how to
properly prepare the engine for storage.
I
14
Publicidad
