Publicidad
Idiomas disponibles
Idiomas disponibles
Generac Portable Products 3000 PSI P ressure Washer
• Secure handle t o thepressure washer using t hefour
provided flange n uts.
• Slowly t ipthepressure washer back inplace and insert
themulti-colored nozzles in thespaces provided i nthe
handle.
Install
Oil Dipstick
on Pump
CAUTION!
You MUST remove the pump's shipping cap
and installthe oil dipstick. Failure to do so will void the
warranty and damagethe pump.
To install
the oil dipstick:
• Make sure your unit is on a level surface.
• Remove and discard the shipping cap located on the
pump (Figure 2).
Pump Oil
Dipstick
• Install the oil dipstick.
Add
Engine Oil
IMPORTANT:
Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
• Place pressure washer on a level surface.
• Refer to the engine owners manual to add recommended
oil to engine.
NOTE: Check oil often during engine break-in. Refer to
engine owner's manual for recommendations.
Add Gasoline
_IL
WARNING!
Never
fill fuel tank indoors. Never
fill fuel tank when engine is running or hot. Do Not
smoke when filling fuel tank.
_IL
ARNING!
Never fill fuel tank completely full.
Provide space for fuel expansion. Wipe away any
fuel spillage from engine and equipment before
starting.
• Use clean regular unleadedfuel and store in approved
clean covered containers. Use clean fill funnels. Never
use "stale" gasoline left over from last season or gasoline
stored for long periods.
• Clean the area around the fuel fill cap, remove the cap.
Slowly fill tank to the bottom of the filler neck (Figure 3).
__
Maximum Fuel Level
Install the fuel cap and wipe up any spilled gasoline.
Connect
Hose and Water
Supply to
Pump
IMPORTANT:
You must attach all hoses before you start
the engine. Starting engine without all hoses connected and
water supplied will damage the pump.
• Uncoil high pressure hose and attach quick connect end
of hose to the base of the spray gun (Figure 4). Pull
down on the collar of the quick connect, slide onto the
spray gun and let go of collar. Tug on hose to be sure of
a tight connection.
/
6
Publicidad
