Publicidad
Idiomas disponibles
Idiomas disponibles
Generac Portable P roducts 3000 PSI P ressure Washer
_
here.
IMPORTANT:
Do Not siphon standing water for the
water supply.Use ONLY cold water (tess than 100°F).
• Connect the garden hose to the water inlet. Tighten by
hand (Figure 5).
CAUTION!
There MUST be at leastten feet of
unrestricted garden hose between the pressure washer
inlet and any flow shut off device, such as a 'Y' shut-off
connector
or other
convenience-type
water
shut-o_
valve.
Damage to pressure washer resulting from disregarding this
warning wilt not be covered by the warranty.
• Similarly, attach the other end of the high pressure hose
to the high pressure outlet on the pump. Pull clown on
the collar of the quick connect, slide onto the pump and
let go of collar. Pull on hose to be sure of a tight
connection.
• Before you connect your garden hose to the water inlet,
inspect the inlet screen (Figure 5). Clean the screen if it
contains debris, replace if damaged. DO NOT RUN THE
PRESSURE WASHER IF THE SCREENIS DAMAGED.
• Turn ON the water and squeeze the trigger on the gun
to purge the pump system of air and debris.
_
AUTION!
Before starting the pressure washer,
be sure you are wearing adequate eye protection.
Checklist
Before
Starting
Engine
Review the unit's assembly to confirm you have performed
all of the following:
Inspectinlet
screen. Do Not
use if damaged;
clean if dirty.
• Make sure the handle is secure.
• Check for properly tightened hose connections.
• Check to make sure that there are no kinks, cuts, or
damageto the high pressure hose.
• Check that oil has been added to the proper level in the
engine crankcase.
• Add the proper gasoline to fuel tank.
• Provide a proper water supply (not to exceed 100°F)at
a minimum flow of 3.3 gallons per minute.
• Be sure to read "Safety Rules" and "How To Use Your
• Run water through your garden hose for 30 seconds to
Pressure Washer" before using the pressure washer.
clean out any debris. Turn off water.
/
7
Publicidad
