Medtronic MiniLink REAL-Time Guia Del Usuario página 7

1. If a green light on the MiniLink is lit or flashing, do not connect it to the
charger. The MiniLink will not charge with its green light on. Wait for
the green light to turn off (approximately 30 seconds), then connect
the MiniLink to the charger.
2. Connect the MiniLink to the charger
by lining it up, flat side down, with the
charger. Push the two components
together fully.
3. Within 10 seconds after the MiniLink
is connected, a green light on the
charger will flash for 1-2 seconds as the
charger powers on. For the rest of the
charging time, the charger's green light
will continue to flash in a pattern of four
flashes with a pause between the four
flashes.
4. When charging is complete, the green light on the charger will stay
on, without flashing, for 15-20 seconds and then turn off.
5. After the green charger light turns off,
disconnect the MiniLink from the charger.
The green light on the MiniLink will flash
for about 5 seconds and then turn off.
Setting up the MiniLink
The serial number is on the flat side of the
transmitter, as shown on the right. See your
monitor user guide for steps on entering this
number.
green light
SN GT2XXXXXXM
- 5 -
MEDTRONIC MINIMED
MiniLink Transmitter
REF MMT-7703XX
SN GT2XXXXXXM
FCC D: OH27703
IPX8
IC: 3458-7703
1234