GE GBVH5140 Manual Del Propietario E Instalación página 19

Installation Instructions
INSTALLING THE WASHER (cont.)
7. Attach lJ-shaI)ed hose guide to tile end of tile drain
hose. Place tile hose in a laundry tub or standpipe
and secure it with the cable tie provided in the
enclosure package.
NOTE: If tile drain hose is placed in a standpipe
without fimning a U shape, a siphoning action could
occm: There m list be an air gap arotmd tile drain hose.
A snug hose fit can also cause a siphoning action.
CableTie / CableTie 7
I
CableTie
8. Plug tile power cord into a grounded outlet.
NOTE: Check to be sure tile power is off at a
circuit breaker/fllse box befl)re plugging tile power
cord into }Ill outlet.
9. Tm'n on tile power at a circuit breaker/fllse box.
10. Read the rest of this Owner's Manual. It contains
valuable and hell)tiff information that will save wm
time
and Illonev,
11. Before starting the washer, check to make sure:
Main power is turned on.
Tile washer is plugged in.
F_ITile water fimcets are tin'ned on.
The unit is level and all fimr leveling legs are firefly
on tile floor.
Tile shil)ping
suppo_l
hardware is removed
and saved.
The drain hose is properly tied up.
There are no leaks at the timcet, drain line
or washen
12. Run tile washer through a complete cycle. Check
fi_r water leaks and proper operation.
13. If wmr washer does not operate, please review
the Before You Ca//[or Service section befln'e
calling fin" service.
14. Place these instructions in a location near the
washer fin" flmue reference.
REPLACEMENT PARTS
If replacement parts are needed fin" your washer; they
can be ordered in tile United States by visiting our
_.Vebsite at ge.com
or by calling
800.GE.CARES.
19