GE GBVH5140 Manual Del Propietario E Instalación página 8

About the washer features.
NOTE:Features may not be a vailable on all washer models.
0
Cycle Signal
SIGNAL
Use tile SIGNAL button to change tile
• _ohune of tile end of cycle signal.
Press the button until you reach tile
desired _olmne.
e ,.i
Prewash (onsomemodels)
Prewash is an extra wash before tile
main wash. Use it tot heavilx soiled
clothes or for clothes with a care label
that recommends prewashing betore
washing. Be sm'e to add high-efficiency
detergent, or tile proper wash additive
to tile prewash dispenser
NOTE: When selecting prewash, it is
recommended to use powder detergent in the
main wash (detergent) compartment.
0 EXTRA
RINSE
Extra Rinse
Use an extra rinse when additional
finsin{* is desired to remoxe excess di_l
and detergent fl'om soiled loads.
Delay Start
You can delay tile start of a wash cycle for
up to 18 hours on models GHDVH626,
GCVH6260, WCVH6260, _,_BVH6240,
WH DVH626, X,VCVH6600, X,VH DVH 660,
GCVH6600 and GHDVH670, and %r up
to 10 horns on models WBVH5100 and
GBVHS140. Press tile OEDIYSTART
button to choose tile ntm]ber of horns
you want to delay tile strut of tile cycle,
then press the SYARTbutton. The
machine will count down and strut
automatically at the correct time,
NOTE" If youforgetto fullyclosethedoor, a
reminder s ignalwill beep reminding youto dosa
NOTE" If youopenthedoorwhenthedelay
is counting down,themachine will enterthe
pause state. You mustclosethedoorandpress
START againin ordertorestartthecountdown.
i ¸
Lock
You can lock tile controls to prevent any
selections fl'om being made. Or you can
lock tile controls after w)u have stnrted a
cycle.
Children cannot accidentally start the washer
by touching pads with this option selected
To lock tile washe_; press and hold tile
lock button tot 3 seconds. To tmlock the
washer controls, press and hold the lock
button tor B seconds.
Tile control lock icon on tile display will
light up when it is on.
NOTE:ThePOWERbutton canstiff be used
when themachineis locked.
8
i ii_ iiiiiiiiiiiii
ii i i i i i i i i
MY CYCLE(onsomemodels)
To save a _wofite cyde, set file d_ired
settings for wash cycle, soil levd, spin speed
and _;_sl/temp settings and hold down file
MgCgCLEbutt{m
for 3 se{ onds. A beep will
sound to indicate file cvde has been saved.
To rise VOtlI" CtlStOill
cycle
press tile
MY CYCLEbutton before washing a load.
T{} change tile saxed cycle set tile
desired settings and hold down tile
MY CYCLE
button fi}x 3 seconds.
NOTE:WhenusingMY CYCLEwash
optionscannotbe modifiedafter the cycle
hasbeenstarted
NOTE:If youchangewash optionswith
MY CYCLE beforestarting thecycle, the
MY CYCLE h_zht w ill turn off and youwill
be returnedto the basecycle.