Publicidad
Idiomas disponibles
Idiomas disponibles
EN
FR
DE
ES
IT
PT
■ Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
■ If any parts are damaged or missing, please call
Greenworkstools customer service for assistance.
WARNING:
If any parts are damaged or missing do not
operate this tool until the parts are replaced.
Failure to heed this warning could result in serious
personal injury.
WARNING:
Do not attempt to modify this tool or create
accessories not recommended for use with this
tool. Any such alteration or modifi cation is misuse
and could result in a hazardous condition leading
to possible serious personal injury.
WARNING:
Do not insert the battery until assembly
is complete. Failure to comply could result in
accidental starting and possible serious personal
injury.
ASSEMBLING THE HANDLE BAR
See Figure 1-2
Align the holes on the upper handle with the holes on
■
the lower handle. Insert the bolts, and tighten them
using the wing nuts provided.
NOTE: Do not use force. If there is binding, continue
to loosen the knobs. Do not allow the switch cable to
become pinched when raising the handlebar.
ASSEMBLING THE WHEELS
See Figure 5
Disconnect and remove the battery.
■
The wheels are used to control the depth of operation.
■
To adjust the height of the wheels.
Place cultivator in a stable position and transport as
■
shown.
Insert the wheel assembly into the support rod .
■
NL
SV
DA NO
FI
HU CS RU
English
INSTALLING THE TINES
See Figure 4
The cultivator has four tines —two inner tines stamped B
and C, and two outer tines stamped A and D. For correct
operation of the unit, the tines must be installed in the
correct orientation.
NOTE: Disconnect and remove the battery. Lean the unit
back on its wheels so that the handlebar rests on the
ground.
OPERATION
■ Place tine C on the tine shaft to the left of the gear box.
The stamped side of the tine should face away from the
gear box.
■ Place tine B on the tine shaft to the right of the gear box.
The stamped side of the tine should face away from the
gear box.
■ Place a felt washer on each side of the tine shaft, and
slide to rest against the inner tines.
■ Place the outer tine stamped D on the left side of the
tine shaft. The stamped side should face in toward tine
C.
■ Place the outer tine stamped A on the right side of the
tine shaft. The stamped side should face in toward tine
B.
10
RO PL
SL
HR ET
LT
LV
SK BG
Publicidad
