Publicidad
Idiomas disponibles
Idiomas disponibles
* This washing machine
is equipped
with automatic
safety functions which detect and diagnose
problems at an
early stage and react appropriately.
When the machine does not function properly or does not function at all,
check the following points before you call the Service Department.
Rattling and clanking noise
Thumping sound
Vibrating noise
Water leaks
Excessive suds
Water does not enter
washer or it enters slowly
Water in the washer does
not drain or drains slowly
• Foreign objects such as coins
or safety pins may be in drum
or pump.
• Heavy wash loads may
produce a thumping sound.
This is normal.
• Have all the transit bolts and
packing been removed?
• Wash load may be unevenly
distributed in the drum.
• Are all the feet resting firmly
on the ground?
• Fill hose connection is loose at
Stop washer and check drum and drain
filter.
If noise continues after washer is restarted,
call for service.
If sound continues, washer is probably out
of balance. Stop and redistribute wash
load.
See Installation Instructions for removing
shipping bolts.
Stop washer and rearrange wash load.
Adjust the leveling feet.
Make sure all four feet are in firm contact
with the floor, while the washer is in the
spin cycle with load.
Check and tighten hose connections.
tap or washer.
• House drain pipes are
clogged.
• Too much detergent or
unsuitable detergent.
Unclog drain pipe. Contact plumber if
necessary.
Reduce detergent amount or use low
sudsing detergent.
• Water supply is not adequate
in area.
• Water supply tap is not
completely open.
• Water inlet hose is bent.
• The filter of the inlet hose
clogged.
• Drain hose is bent or clogged.
• The drain filter is clogged.
Check another tap in the house.
Fully open tap.
Straighten hose.
Check the filter of the inlet hose.
Clean and straighten the drain hose.
Clean the drain filter.
19
Publicidad
