Worx WG216E Manual página 10

ACCESSORY
WG261E
Blade sheath
Safety guard
Charger 1 (WA3880)
Battery pack 1 (WA3551)
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended use
The machine is intended for cutting and trimming
hedges and bushes in domestic use.
WARNING! Do not use the product
without attaching the guard and front
handle.
10
ASSEMBLY & OPERATION
ACTION
ASSEMBLY
Assembling the safe guard
Assembling the Front Handle
NOTE: Loosen the long screw first
before assembling the front handle.
NOTE: If the handle is assembled
incorrectly, the tool will not power on.
Checking the battery charge
condition(Only for WG261E)
Installing and Removing the battery pack
Charging the battery pack
Your battery pack is UNCHARGED, you
must charge before use.
More details can be found in WA3760/
WA3880 manual
OPERATION
Starting and stopping
Cordless Hedge Trimmer
WG261E.1 WG261E.9
1 1
1 1
1 (WA3760)
2 (WA3550.1)
FIGURE
See Fig. A
See Fig.
B1, B2, B3
See Fig. C
See Fig. D
See Fig.
E1, E2
Top cutting
WARNING: If any parts are
missing, damaged or broken, do
not operate your hedge trimmer until
all damaged parts have been replaced
1
or repaired. Failure to do so could result
1
in serious personal injury. DO NOT
USE WITHOUT FRONT HANDLE AND
/
SAFETY GUARD.
/
Side cutting
Lubricating the Cutting Blade
NOTE: It is important to use only the
recommended standard lubricating oil
(WD-40) to avoid damage to the blade.
HOW TO USE YOUR HEDGE
TRIMMER
Note that the front switch lever can be activated
on three sides, giving you many choices for a
comfortable grip. Before cutting an area, inspect
it first and remove any foreign objects that could
become thrown or entangled in the blades. Always
hold the trimmer with both hands and with the
blade away from you before turning it on.
When trimming new growth, use a wide sweeping
action so that the stems are fed directly into the
blade. (See Fig. F1&F2)
Allow the cutting blades to reach full speed before
cutting. When operating, keep the cutting blades
away from people and objects such as walls, large
stones, trees, vehicles, etc.
If the blade stalls, immediately stop the trimmer.
Release the two Switch components (6&7) before
attempting to clear jammed debris from the cutting
blades.
Wear gloves when trimming thorny or prickly
growth.
Do not attempt to cut stems that are too thick for
the cutting blade.
TOP CUTTING
Use a wide sweeping motion (See Fig. F1). A slight
downward tilt of the cutting blades in the direction
of motion gives the best cutting results.
SIDE CUTTING
When trimming the sides of the hedge, begin at the
bottom and cut upwards (See Fig. F2), tapering the
hedge inward at the top. This shape will expose
more of the hedge, resulting in a more uniformed
growth.
See Fig. F1
See Fig. F2
See Fig. G
EN