Publicidad
Idiomas disponibles
Idiomas disponibles
- Keep product and batteries away from fire
and do not expose them to direct sunlight
or high temperatures.
- If the product becomes abnormally hot or
smelly, changes color or if charging takes
longer than usual, stop using and charging
the product and contact Philips.
- Do not place products and their batteries in
microwave ovens or on induction cookers.
- Do not open, modify, pierce, damage or
dismantle the product or battery to prevent
batteries from heating up or releasing toxic
or hazardous substances. Do not short-
circuit, overcharge or reverse charge
batteries.
- This appliance contains batteries that are
non-replaceable. When the battery is at
end of life, the appliance shall be properly
disposed of, see section on recycling.
Storage and transportation conditions
Temperature -10°C to 60°C (14 °F to 140 °F).
Electromagnetic fields (EMF)
This Philips appliance complies with all
applicable standards and regulations
regarding exposure to electromagnetic fields.
Explanation of symbols
The following symbols may appear on the
product:
- Read Operator's Manual (Fig. 2).
- Detachable Power Supply Part (Fig. 3): The
"xxxxxx" indicates the model number of the
approved chargers to be used.
Introduction
Congratulations on your purchase and
welcome to Philips! To fully benefit from the
support that Philips offers, register your
product at www.philips.com/welcome.
Intended use
Philips One power toothbrushes are intended
to remove adherent plaque and food debris
from the teeth to reduce tooth decay and
improve and maintain oral health. Philips One
power toothbrushes are intended for
consumer home use. Use by children should
be with adult supervision.
Your Philips One (Fig. 1)
1 Handle
2 Power button
3 Battery light indicator
4 Charging port
Accessories:
5 Brush head(s)
6 Travel case
7 Travel case lid
8 Brush head travel cap
9 USB-A to small plug
Note: Accessories included may vary based on
the model purchased.
Getting started
Attaching the brush head
1 Align the brush head so the bristles point in
the same direction as the front of the
handle. Press the brush head down onto
the metal shaft (Fig. 4).
Note: It is normal to see a slight gap between
the brush head and the handle (Fig. 5). This
allows the brush head to vibrate properly.
Charging your Philips One
1 Plug the USB-A charging cable into the
charging port at the bottom of the handle
(Fig. 6).
2 Connect the USB-A charging cable into a 5V
USB wall adapter (Type A).
Note: Wall adapter not included. Only use
5V adapter (Type A).
3 Your Philips One beeps twice to indicate
that the toothbrush is charging.
4 Your toothbrush continues to charge until
it is fully charged.
- When the toothbrush is charging, the
battery indicator fades up and down in
white.
- When fully charged, the battery
indicator lights up solid white and turns
off after 30 seconds of being fully
charged.
Note: It can take up to 8 hours to fully
charge the battery, but you can use the
toothbrush before it is fully charged.
Publicidad
