Descargar Imprimir esta página

Philips One HY1200 Serie Manual Del Usuario página 5

Ocultar thumbs Ver también para One HY1200 Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

occurs, please follow up with a dental
professional.
Battery status
This Philips One toothbrush is designed to
provide at least 60 brushing sessions after it
has been fully charged for 8 hours. This allows
sufficient charge for 1 month's usage if you
brush 2 times a day (each session lasting 2
minutes).
When the battery light indicator flashes amber
it is time to charge your Philips One (see
chapter Charging your Philips One). The table
below specifies the battery states:
Number of
brushings
remaining
40-60
brushings
7-39
brushings
≤6 brushings
0 brushings
remain
Note: When the battery is completely empty,
the toothbrush turns off. The toothbrush will
not turn on until battery is recharged.
Toothbrush does not turn on while charging.
Note: Battery usage time is expected to reduce
over product lifetime.
Cleaning
You should clean your toothbrush and
accessories regularly to remove toothpaste
and other residue. Failure to clean your
product may result in an unhygienic product
and damage to it may occur.
Warning: Do not clean product or
accessories in dishwasher, microwave,
with chemicals or with boiling hot water.
Toothbrush handle
1 Remove the brush head and rinse the metal
shaft area with warm water (Fig. 14). Make
sure you remove any residual toothpaste.
2 Wipe the entire surface of the handle with
a damp cloth.
Note: Do not tap the handle on the sink to
remove excess water.
Cleaning brush head
1 Rinse the brush head and bristles after each
use.
2 Remove the brush head from the handle
and rinse the brush head connection with
warm water at least once a week.
Cleaning travel case or brush head travel
cap
Rinse the travel case or brush head travel cap
weekly with warm water and wipe clean with
a damp cloth.
Cleaning the USB-A charging cable and
charging port
1 Use compressed air to clean the charging
port on the toothbrush handle and
connector on the USB-A charging cable.
2 Use a slightly dampened cloth to wipe the
USB-A charging cable then leave to air dry
completely.
Note: Avoid contact of the charging port and
connections with water. After cleaning, make
sure the USB-A charging cable is completely
dry before you connect it to a USB power
supply unit.
Storage
If you are not going to use the product for a
long time, clean it (see 'Cleaning'), charge it
fully, and store it in a cool and dry place away
from direct sunlight.
Replacement
Brush head
Replace the brush heads every 3 months to
achieve optimal results. Only Philips One brush
heads are compatible with Philips One.
Locating the model number
Remove brush head from handle. Look at the
top of the handle near the metal shaft for the
model number (HY120X).
Battery
indicator
White- solid
White- fades
up and down
Amber-
flashing
Amber-
flashing
Beep sound
-
-
5 beeps after
brushing
5 beeps x 2

Publicidad

loading

Este manual también es adecuado para:

One hy1200/26One hy1200/25