Publicidad
Idiomas disponibles
Idiomas disponibles
B
Product usage
Assembly
WARNING
Before assembling or disassembling the unit, always disconnect the unit from
the mains supply.
Tool required: Phillips screwdriver (crosshead), not supplied.
Assembling the stand
1.
Unplug the unit from the mains socket.
2.
Remove the 4 screws (Q) from the bars (S, T) with a screwdriver by turning them anti-
clockwise.
3.
Cross bar A (S) over bar B (T) to interlock them.
4.
Place the outer tube (P) on top, making sure to align the 4 holes in the bars with the
holes in the flange of the outer tube. Secure the flange to the bars with the 4 screws (Q).
5.
Remove the height adjustment collar (O) from the top of the outer tube (P) by turning
it anti-clockwise.
Insert the base decorative cap (R) on the outer tube (P), and slide it down onto the assembly.
6.
Replace the height adjustment collar (O) on top of the outer tube (P). Pull the inner
tube (N) slightly out of the outer tube, then tighten the collar by turning it clockwise.
7.
Insert the main body (I, J) onto the inner tube (N) and tighten the locking knob (M)
clockwise to secure it in place.
Assembling the fan head
1.
Remove the plastic mounting nut (E) from the front of the motor housing (I) by rotating
it anti-clockwise.
2.
Position the rear grille (F) against the front of the motor housing (I) with the handle
at the top and facing backwards, making sure that the 2 guide pins on the motor housing
are correctly inserted into the holes in the rear grille.
Secure the rear grille with the plastic mounting nut (E) by turning it clockwise. Do not
overtighten the nut.
3.
Push the centre of the fan blades (D) onto the motor shaft (G), making sure that the
2 slots on the back of the blades fit with the 2 pins on the sides of the motor shaft.
Tighten the blade cap (C) on the motor shaft (G) by turning it anti-clockwise.
4.
Open the clips on the rim of the front grille (B), then hook the bracket at the top of
the front grille onto the rear grille (F).
15
EN
Publicidad
