Publicidad
Idiomas disponibles
Idiomas disponibles
3.
Press inward
on tab on the engine
baffle to release it from
the baffle bracket. See Fig. 7-3.
4.
Figure 7-3
Slide belt off of engine
pulley and thread through
the
opening
in the deck. See Figure 7-4.
©
Figure
7-4
NOTE:When
removing
belt on units with a 25mm adapter,
the pulleys and washers
may also break free from the
crankshaft.
Be sure to make note of the orientation
of these
items for reassembly.
5.
Replace with new belt, making
sure belt is firmly seated on
engine
pulley while pulling
from the other side and sliding
it around the transmission
pulley.
6.
Reattach engine
baffle and reassemble
blade as described
in the previous
section.
7.
Turn mower
back over and make sure belt is seated on the
transmission
pulley. Pivot the belt keeper wire back into its
operating
position
and snap into the slot provided.
8.
Reassemble
front drive cover.
Off-Season Storage
The following steps should be taken to prepare your lawn mower
for storage.
Clean and lubricate mower thoroughly as described in the
lubrication instructions.
Do not use a pressure washer or garden
hose to clean your
unit.
Coat mower's cutting
blade with chassis grease to prevent
rusting.
Refer to engine manual for correct engine
storage
instructions.
Store mower in a dry, clean area. Do not store next to
corrosive
materials,
such as fertilizer.
When storing
any type of power
equipment
in a poorly
ventilated
or metal storage
shed, care should
be taken to
rust-proof
the equipment.
Using a light oil or silicone, coat the
equipment,
especially
cables and all moving
parts of your lawn
mower
before storage.
SECTION 7 -- SERVICE
17
Publicidad
