Zumtobel nBOX Serie Puesta En Operación Rápida página 32

Connection: voltage supply
Connect voltage supply
10
3. Connect the N and L conductors with the 2-pin plug (terminal
assignment in image on left).
4. Connect the plug (voltage supply) and cables to the battery
recharging device on the bottom of the AC module.
5. Connect the network cable to the back of the AC module.
6. Mount the AC module on the nBox and secure with a screw
(Torx).
Note
i
When using a torque spanner, ensure that the torque
does not exceed 2.9 Nm, as otherwise the bracket may
break.
nBox, Quick commissioning 2.0 | 07.2022 | en
Done