Publicidad
Step 18
å
Carefully turn your unit over onto its front edges. Tighten the HIDDEN
CAMS in the BACKS (F).
å
Unfold the LARGE BACK (O) and lay it over your unit. Push the SAFETY STRAP
through the large hole in the LARGE BACK (O).
å
Turn eight BLACK 9/16" LARGE HEAD SCREWS (1S) into the bottom edge of
the LARGE BACK (O) and into the BACKS (F). Do not completely tighten the
SCREWS at this time.
å
Then, making sure that the top edge of the LARGE BACK (O) sits slightly
below the top edge of your unit, fasten the top and side edges of the LARGE
BACK to your unit using the NAILS (1N).
å
Now, completely tighten the SCREWS in the bottom edge of the LARGE BACK (O).
å
NOTE: Be sure to tap NAILS into the holes that line up over the UPRIGHT (E).
Tighten the
HIDDEN CAMS.
BLACK 9/16" LARGE HEAD SCREW
(8 used in this step)
Page 22
O
F
1S
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
These holes must line up
over the UPRIGHT (E).
E
F
430044
Caution
1N
NAIL
(31 used for the BACK)
Push the
SAFETY STRAP
through the hole.
www.sauder.com/service
8
Publicidad
