Publicidad
Step 20
1
J
Label
D44
å
Pull the SMALL DRAWER FRONT BRACKETS (8G) apart and slide
them into the grooves in the SMALL DRAWER SIDES (D44 and D45
with label). You may need to gently tap them in with a hammer.
å
NOTE: The DRAWER FRONT BRACKETS are marked "RH" and "LH"
for easy identification.
å
Fasten the SMALL LEFT DRAWER FRONT (J) to the SMALL
DRAWER FRONT BRACKETS (8G). Use four BLACK 9/16" LARGE
HEAD SCREWS (1S).
3
M67
1
Surface with
HIDDEN CAM
å
Push a HIDDEN CAM (1F) into a DRAWER BRACE (M67). Then, insert
the metal end of a CAM DOWEL (2F) into the HIDDEN CAM.
å
Fasten the DRAWER BRACE (M67) to the SMALL LEFT
DRAWER FRONT (J). Tighten one HIDDEN CAM.
Page 24
Push down
8G
D45
BLACK 9/16" LARGE HEAD SCREW
(8 used in this step)
Arrow
Metal end
1F
2F
Hidden part using
recycled material.
Color may vary.
M67
J
2
D44
1S
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide a DRAWER BOTTOM (D974) into the grooves in
the SMALL DRAWER SIDES (D44 and D45) and SMALL
LEFT DRAWER FRONT (J).
4
D44
å
Fasten the SMALL DRAWER BACK (D166) to the SMALL
DRAWER SIDES (D44 and D45) and DRAWER BRACE (M67).
Use five BLACK 1-9/16" FLAT HEAD SCREWS (30S). Repeat
this step using the SMALL RIGHT DRAWER FRONT (K).
430044
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
D974
U n
fi n
i s h
e d
s u
r f a
c e
J
D45
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(10 used in this step)
D166
M67
D45
www.sauder.com/service
11
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Publicidad
