Publicidad
Idiomas disponibles
Idiomas disponibles
LISTENING TOEXTERNAL
SOURCES
POWER--
1
To play equipment
connected
to the VIDEOiAUX
jacks, 3roceed
as follows.
1 Press the VIDEO/AUX
button.
VIDEO appears on the display.
2 Play the connected
equipment.
To change
a source
name
in the display
When
the VIDEO/AUX
button
is pressed.
VIDEO
is displayed
initially.
It can be cnanged
to AUX or TV.
With the power on, press the POWER
button while pressing
the
VIDEO/AUX
button.
Repeat
the procedure
to select one of the names.
To adjust the sound level of the external source
When the sound level of the external source is much higher or
much ower than that of other function sources, adjust it as
follows.
1 Press the VIDEOiAUX button and play the equipment.
2 Turn the VIDEO/AUX INPUT LEVEL control on the rear panel
until the souna level eecomes the same as that of other
function sources.
CAREAND MAINTENANCE
Occasional
care and maintenance
of the unit and the software
are needed
to optimize
the performance
of your unit.
To clean the cabinet
Use a soft and dry cloth.
If the surfaces
are extremely
dirty,
use a soft cloth
lightly
moistened
with
mild detergent
solution.
Do not use strong
solvents,
such as alcohol,
benzine
or thinner
as these
could
damage
the finish of the unit.
To clean
the heads
and tape
paths
After every
10 hours
of use, clean the heads
and tape
paths
with a head cleaning
cassette
or cotton
swab
moistened
with
cleaning
fluid or denatured
alcohol.
(These
cleaning
kits are
commercially
available.)
When cleaning
with a cotton swab, wipe the recording/playback
head, erasure
head (deck 2 only), capstans,
and pinchrollers.
Playback head
Cotton swab
Capstan
_
'_
//
Capstan
Pinchrotler
Erasure head
Pinchroller
After
cleaning
the heads
and tape
paths
with
a liquid
head
cleaning
cassette
or a moistened
swab,
wait until the cleaned
parts are completely
dry before inserting
the tapes.
To demagnetize
the heads
The heads may become
magnetized
after long-term
use. This
may narrow
the output
range of recorded
tapes and increase
noise.
After 20 to 30 hours
use, demagnetize
the heads with
any commercially
available
demagnetizer.
Care
of discs
• When a disc becomes
dirty, wipe the disc from the center
out
with a cleaning
cloth.
23
ENGLISH
• After playing
a disc, store the disc in its case. Do not leave the
disc in places that are hot or humid.
Care
of tapes
• Store tapes in their cases after use.
• Do not leave tapes near magnets,
motors,
television
sets, or
any source
of magnetism.
This
will downgrade
the sound
quality and cause noise.
• Do not expose
tapes to direct sunlight,
or leave them in a car
parked
in direct sunlight.
Publicidad
