Publicidad
Idiomas disponibles
Idiomas disponibles
MANUAL TUNING
PRESETTING S TATIONS
1
2
/
1
-- MONO
TUNER
2-
• CLEAR
1
1 Press the TUNER/BAND
button repeatedly
to
select the desired band.
-* FM "_*
AM q
If the power is turned off, the previously
tuned station
will be
played
(Direct
Play Function).
2 Press the I<l_li DOWN or IHH UP button to select
a station.
Each time the button is pressed,
the frequency
changes.
When a station is received, "TUNE" is displayed
for 2 seconds.
During FM stereo
reception,
lie@)}] is displayed.
The unit can store a total of 32 preset stations.
When a station
is stored,
a preset
number
is assigned
to the station.
Use the
preset number
to tune in to a preset
station
directly.
1 Press the TUNER/BAND
button to select a band,
and press the I<<1 DOWN or _R
UP button to
select a station,
2 Press the II SET button
to store the station.
A station is assigned a preset number, beginning from 1 in
consecutive order for each band.
Frequency
To search for a station quickly (Auto Search)
Keep the I'<_ DOWN or IH_I UP button pressed until the tuner
starts searching for a station. After tuning in to a station, the
search stops.
To stop the Auto Search manually, press the 1_14DOWN or _1
UP button.
• The Auto Search may not stop at stations with very weak
signals.
When
an FM stereo
broadcast
contains
noise
Press
the REPEAT/MONO
TUNER
button
so that "MONO"
appears
on the display.
Noise is reduced,
although
reception
is monaural,
MONO
Preset number
3 Repeat
steps 1 and 2.
The nextstation will not be stored if a total of 32 preset stations
have already been stored for all the bands.
To clear a preset station
Select the preset number of the station to be cleared. Then, press
the • CLEAR button, and press the II SET button within 4
seconds.
The preset numbers of all other stations in the band with higher
numbers are also decreased by one.
To restore
stereo
reception,
press the button
so that MONO
disappears.
To change
the AM tuning
interval
The default setting
of the AM tuning
interval
is 10 kHz/step.
If
you use this unit in an area where the frequency
allocation
system
is 9 kHz/step,
change the tuning interval,
Press
the POWER
button
while
pressing
the TUNER/BAND
button.
TO reset the interval,
repeat this procedure,
When the AM tuning interval
is changed,
all preset stations
(see
"PRESETTING
STATIONS")
are cleared.
The preset
stations
have to be set again.
ENGLISH
8
Publicidad
