Publicidad
Idiomas disponibles
Idiomas disponibles
f a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING : Under no circumstances should you Jiry to repair the set yourself, as this would invalidate the guarantee.
P
on
POSSIBLE CAUSE
_ _ | REMEDY
The signal is too weak.
Adjust the antenna.
The signal strength is too weak.
Adjust the antenna.
The TV or VCR is too close to the stereo system.
Separate the stereo system from the TV or VCR.
:
Connect an external anfenna for better reception.
No cassette in the cassette deck.
Insert a blank casseife into the cassette deck.
The small tab has been broken.
Put a piece of clear adhesive tape over the opening.
Dirty tape heads.
ee section on cassette aeck
maintenance.
Magnetic build-up in the record/playback head
Use demagnetizing cassette
_| Coniamination of the capstans or pressure rollers. | See section on cassette deck maintenance.
The disc is inserted upside down.
Place CD with printed side up
Moisture condensation.
Wait uniil lens has adjusted to the room temperature
There is no disc in the CD tray.
Insert a CD.
The CD is dirty, badly scratched or warped.
Replace or clean the CD.
Set does not react when buttons are pressed.
Press ON/OFF © fo switch the unit off, then switch it on
again. Or, unplug the AC power plug from the
wall outlet, then plug it in again.
Volume is not turned up.
Adjust Volume.
The headphones are connécted.
Disconnect the headphones.
Speakers are not connected or are connected
Check that the speakers are connected correctly.
wrongly.
.
Make sure that the stripped speaker wire is clamped.
There has been a power interruption.
Reset the clock.
The distance to the system is too large.
Reduce the distance.
Batteries are inserted incorrectly.
Hel the baiteries correctly.
Batteries are empty.
eplace the batteries.
Wrong sound source is selected.
elect the sound source before pressing the
cea button, (PLAY, PREV/NEXT, eic.)
Demo mode is switched on.
Press ON/OFF © or DEMO to switch off demo mode.
35
Publicidad
