Bosch RA1200 Instrucciones De Funcionamiento Y Seguridad página 12

BM 2610909346 5/03 5/12/03
INSERT RINGS
When smaller diameter router bits are used, use
the mounting plate's throat insert rings to
provide additional support to the workpiece as it
nears the bit and minimize the amount of debris
that falls through the throat opening. (Fig. 13)
The rings are designed to fit snugly to stay in
place and remain level. Considerable force may
be required to install and remove the rings.
• To insert the outer ring, press it into the
mounting plate. Make sure the tabs on the
ring goes into one of the notches in the
mounting plate.
• To insert the inner ring, press it into the outer
ring (considerable force may be required).
• To remove, tap out from the back side with a
soft mallet or piece of wood.
Don't pry them out or they
CAUTION
!
may be damaged. If you
want a slightly looser fit, lightly sand the outside
diameter of each ring.
• When removing the inner ring, it may be
necessary to press down on the outer ring.
ATTACHING FENCE FACES TO FENCE
Using 3/8" x 2" carriage bolts and black wing
knobs, tighten the fence faces against fence.
The fence faces are symmetrical and can be
installed on either side of the fence with either
end of the face facing center. (Fig. 14)
11:52 AM Page 12
Router Table Assembly
FIG. 13
STARTER
PIN HOLES
FIG. 14
WING
KNOB
-12-
INNER RING
OUTER RING
3/8" X 2"
FENCE
CARRIAGE
FACE
BOLT