On-Off Switch - Bosch RA1200 Instrucciones De Funcionamiento Y Seguridad

BM 2610909346 5/03 5/12/03

ON-OFF SWITCH

Your router should be turned "ON" and "OFF"
using the router table switch.
This switch has a 15 amp rating is intended only
for turning the router "ON" and "OFF". Do not
use it to operate additional equipment, such as
a vacuum cleaner.
Always keep the workpiece
CAUTION
!
away from the bit when
turning the unit on or off. Contact the bit with
the workpiece only after the router has reached
the full desired speed, and remove the
workpiece before turning it off. Operating in this
manner will prolong switch and motor life and
will greatly increase the quality of your work.
Before turning the table's switch on, make sure
router's own switch is set to its "ON" position.
TO TURN THE TOOL "ON": Lift the switch to
turn the unit "ON".
TO TURN THE TOOL "OFF": Press the switch
in to turn it "OFF".
OPTIONAL MITER GAUGE
The Bosch table saw miter gauge can also be
inserted into the track in the middle of the table.
(A T-slot miter gauge can also be used.) A miter
guide will allow angled workpieces to be
precisely guided across the table. (Fig. 27)
Do not use the miter gauge
WARNING
!
and the fence at the same
time.
OFFSETTING THE OUTFEED FENCE
AND JOINERY
When trimming the entire edge of a thin
workpiece, the outfeed fence face can be
moved forward to provide the necessary
support to prevent workpiece chatter. The
outfeed fence can also be moved forward for
joinery, which is the process of making flat,
square and straight mating edges.
Using a router table for jointing has several
advantages over other methods, such as using
a freestanding power jointer, though it cannot
completely replace a power jointer.
11:52 AM Page 19
Operating Instructions
FIG. 28
When the router table is not in use, we suggest
locking the switch in the off position with a lock
(not included).
FIG. 27
• Small and short pieces of wood can be safely
and successfully routed because the opening
between the faces can be adjusted down to a
minimum.
• Because routers spin much faster than typical
jointers, the cut quality is much better. This is
especially useful on types of woods that are
prone to tear-out.
Shims are provided to easily and accurately
position the outfeed fence forward and to
provide the necessary support.
-19-
LOCK
(NOT INCLUDED)
ON
OFF