Bosch RA1200 Instrucciones De Funcionamiento Y Seguridad página 15

BM 2610909346 5/03 5/12/03
ROUTER PREPARATION
Install the desired bit into the router according
the router's instructions. (It is often easier to do
this when the router and mounting plate
assembly have been removed from the router
table.)
Install or remove insert rings as appropriate to
minimize the opening without touching the
desired bit.
Adjust the router bit to the desired height
according the router's instructions.
POSITIONING THE FENCE FOR
EDGE FORMING STRAIGHT PIECES
For safe operation and
WARNING
!
quality routing results when
edge-forming straight pieces, the workpiece,
fence, and router bit must be positioned
according to these guidelines:
• The workpiece must be positioned against
the fence faces and must slide smoothly
along the faces.
• If a piloted (or "bearing") bit is used, the front
of the bearing should be even with the front
of the fence faces.
POSITIONING THE FENCE FOR
SLOTTING CUTS
Slotting cuts are made in the middle of the
workpiece, such as grooves and dados. Mount
the fence to the table using the front or rear set
of holes, as appropriate (Fig. 22).
For safe operation and
WARNING
!
quality
slotting, the workpiece and router bit must
be positioned as follows:
• Only non-piloted bits can be used.
• The bit must not cut though the top of the
workpiece.
• Always feed the workpiece from right to left.
11:52 AM Page 15
Operating Instructions
POSITIONING THE FENCE FACES
The fence faces can be moved left and right to
properly position the faces for the desired
operation. Loosen the fence face wing knobs.
! WARNING
workpiece, position the faces as closely as
possible to the bit without touching the bit.
Once the proper location has been determined,
secure the faces in place by tightening the wing
knobs behind the fence (Fig. 14).
Additional fence face sets are available from
your Bosch dealer.
FENCE FACE
BEARING
results when
FENCE FACE
NON-BEARING
BIT
-15-
For safe operation and to
avoid tear-out on
FIG. 21
DIRECTION
OF FEED
FENCE FACE
WORKPIECE
BIT
TOP VIEW
FIG. 22
DIRECTION
OF FEED
FENCE FACE
WORKPIECE
TOP VIEW
the