Change Of Specimen; Finish Work - Nahita ZFP011 Manual De Instrucciones

3. Turn Fast marching handwheel to move specimen to back position.
4. Insert the blade into blade holder from the side and clamp enough
5. Upturn the knife guard for finger protection, cover knife edge
6. Adjust the angle of slice (try it, range 0 to 3)
7. Allow the blade holder get closer to specimen as far as possible
8. Adjust the position of specimen as far as possible parallel with the edge
9. Release the handwheel
Warning: turn the handwheel uniformly when slicing. When slicing hard tissue specimen,
lower the speed to turning handwheel in order to attain ideal slice.
10. Turn handwheel, start trimming
11. When attain the surface which you want to slice, stop trimming.
12. Select the desired thickness, turn the handwheel clockwise with a uniform speed and
slice.

8.6 Change of specimen

Warning: before installing or exchanging specimen clamp and working clearance, handwheel
must be locked and the cutting edge covered with the knife guard.
1. Lock handwheel
2. Upturn the knife guard for finger protection, cover knife edge
3. Release specimen clamp and carry down specimen, change a new one

8.7 Finish work

1. Lock handwheel
2. Release sickle clip and take out the blade from blade holder, put blade into knife box.
3. Carry down specimen from specimen clamp
4. Clean out all of slice waste
5. Clean instrument
Manual de instrucciones Instruction manual 41 Versión Version 2017