Briggs & Stratton 020228 Manual Del Usuario página 10

Section 4: Operation
8. When starting engine, position yourself as recommended
in Figure I I and start engine according to instructions
given in engine user's manual.Also see operating
instructions tag located on the pressure washel:
I WARNING
When starting engine, Full cord slowly until resistance is felt
and then Full rapidly to avoid Idcl<bacl<.
If engine starts and fails to continue to run or if increased
resistance is felt during starting pull aEempts, squeeze trigger
on spray gun.
NOTE: Always keep the throttle lever in the "Fast"
)osiuon when operaung the pressure washen
WARNING
DO NOT touch hot surfaces and avoid hot exhaust gases.
Allow equipment to cool before touching.
The pressure washer must be at least 5 feet from structures
having combustible walls and/or other combustible materials.
Keep at least 3 feet of clearance on all sides of pressure
washer for adequate cooling, maintenance and servicing.
Reflective exhaust heat may damage fuel tank causing fire.
Code of Federal Regulation (CFR) Title 36 Parks, Forests, and
Public Property require equipment powered by an internal
combustion engine to have a spark arrester, maintained in
effective working order, complying to USDA Forest service
standard 5100- I C or later revision. In the State of California a
spark arrester is required under section 4442 of the California
Public resources code. Other states may have similar laws.
How to Stop Your Pressure Washer
I. Let engine idle for two minutes.
2. Turn engine off according to insu*ucdons given in
engine user's manual.
3. Squeeze trigger on spray gun to relieve trapped
pressure in hose to avoid injury.
WARNING
Keep high pressure hose connected to pump and spray gun
while system is pressurized.
Squeeze trigger on spray gun to relieve trapped pressure,
every time you sto F engine. Engage trigger lock on spray gun.
NOTE: A small amount of water will squirt out when
pressure is released.
4, Engage trigger loci< on spray gun when not in use.
O