Briggs & Stratton 020228 Manual Del Usuario página 14

Maintenance
SPECiFiCATiONS
Maximum Outlet Pressure ............... 2200 psi
Maximum Flow Rate .... 2.2 gallons per minute (gpm)
Detergent Use detergent approved for pressure washers
Water
Supply
................ Not to Exceed 100°F
Temperature
Automatic Coo[ ............. Will cycle when water
Down System reaches 125 °- I S5°F
Shipping Weight ........................... 54 Ibs.
GENERAL MAINTENANCE
RECOMMENDATIONS
The pressure washer warranty does not cover items that
have been subjected to operator abuse or negligence.To
receive full value fl*om the warranty, the operator must
maintain the pressure washer as instructed in this manual.
NOTE: Should you have questions about replacing
components on your pressure washer, please call
1-800-743-4 [ [ 5 for assistance.
• Some adjustments will need to be made periodically to
properly maintain your pressure washen
• All maintenance in this manual and the engine user's
manual should be made at least once each season.
• Once a year you should clean or replace the spark plug,
clean or replace the air filter and check the spray gun and
nozzle extension assembly for weacA new spark plug and
clean air filter assure proper fuel-air mixture and help your
engine run better and last Iongen Please refer to your
engine user's manual for more details.
• If equipped with inflatable tires, keep the air pressure at
the value marked on the tire or within IS and 40 psi.
Before Each Use
• Check engine oil level.
Check water inlet screen for damage.
Check in-line filter for damage.
Check high pressure hose for leaks.
Check chemical injection hose and filter for damage.
Check spray gun and nozzle extension for leaks.
Rinse out garden hose to flush out debris.
PRESSURE WASHER
HAINTENANCE
Check and Clean
inlet
Screen
Examine the screen on the water inlet. Clean it if the
screen is clogged or replace it if screen is damaged.
Check High Pressure Hose
The high pressure hose can develop leaks from wear,
Idnl<ing, or abuse. Inspect the hose each time before using
it. Check for cuts, leaks, abrasions or bulging of covel.
damage or movement of couplings. If any of these
conditions exist, replace the hose immediately.
WARNING
NEVER repair high pressure hose. Replace it.
Replacement hose rating HUST exceed maximum pressure
rating of unit.
Check
Chemical Injection
Hose
Examine the filter on the detergent tube and clean if
clogged.The tube should fit tightly on the barbed fitting.
Examine the tube for leaks or tears. Replace the filter or
tube if either is damaged.
Check Gun and Nozzle Extension
Examine the hose connection co the spray gun and make
sure it is secure.Test the trigger by pressing it and making
sure it "springs back" into place when you release it. Put
the trigger lock in the ON position and test the triggen
You should not be able to press the triggen
0