Publicidad
Idiomas disponibles
Idiomas disponibles
Installation | nstructions
AW Pre-Test Checklist
Remove all protective film, if present, and
any stickers.
Check to be sure that all wiring is secure and
Check that the bottom trim is installed prop-
erly (see page 12).
Vd
Check to be sure the mounting screws are
not pinched or in contact with moving parts.
NOTE TO ELECTRICIAN: You must unplug
the green wire (near where the long flexible
conduit exits the unit) when conducting
high-potential testing. Please replug prior
to operation.
Vid
installed and flush with the side trim (see
page 11).
Operation Checkli
st
Remove all items from the inside
NOTE TO ELECTRICIAN: The power leads
wy
of the oven.
Check that conduit is securely connected to
the junction box.
Turn on the power to the oven. (Refer to your
Owner's Manual, Verify that the bake and
broil units, and all cooking functions operate
properly.
Check that the circuit breaker is not tripped
nor the house fuse blown.
See your Owner's Manual for
troubleshooting list.
If"bAd" "LInE" appears in the display when
the power is turned on, the house wiring
connections are incorrect.
es
a
PROBE
TIMER
clock
mel
e e
ie
ahd
PROBE
©O-48-©
cook
DELAY
TIME
START
supplied with this appliance are UL
recognized for connections to larger gauge
household wiring. The insulation of these
leads is rated at temperatures much higher
than the temperature rating of household
wiring. The current carrying capacity of a
conductor
is governed by the wire gauge and also
the temperature rating of the insulation
around the wire.
NOTE: ALUMINUM WIRING
A. WARNING: improper
CONNECTION OF ALUMINUM HOUSE
WIRING TO THE COPPER LEADS CAN
RESULT IN AN ELECTRICAL HAZARD OR
FIRE.
Splice copper wires to aluminum wiring
using special connectors designed
and UL approved for joining copper to
aluminum,
and follow the manufacturer's
recommended connector procedure
closely.
NOTE: Wire used, location and
enclosure of splices, etc., must conform
to good wiring practice and local codes.
14
Publicidad
