Descargar Imprimir esta página

GE ZET1 Serie Instrucciones De Instalación página 8

Publicidad

Idiomas disponibles

Idiomas disponibles

Cabinetry
A7 | Single Oven Cutout
for Installation Below
a Monogram Advantium
or Microwave Oven
ry
Per Advantium or
.
Microwave Oven
_|.
2" (5.1 cm) Min.
Requirement
~
| |
the oven.
NOTE: The middle rail separating the two
openings may need to be larger than the 2"
(5.1 cm) minimum shown. Always refer to the
individual installation instructions packed with
each product for specific requirements.
Combined Advantium or
Microwave Oven and Wall Oven
Installation:
When installed in combination with a
Monogram single wall oven, use separate electri-
cal junction boxes.
e Refer to the Advantium or microwave
oven installation instructions for electrical
requirements of that product.
e These connections must be made
by a qualified electrician. All electrical
connections must meet National Electrical
Code or prevailing local codes.
A8
Single Oven Cutout for
Note: Install the oven
only with specific
models listed on the
a
|
|e
label located on top of
Me
d y
Installation Between a
Monogram Advantium or
Microwave Oven and a
Monogram Warming Drawer
Per Advantium or
Microwave Oven
Requirement _
2" (5.1 cm) Min.
Per Warming Drawer ~
Requirement
NOTE: Additional clearances may be required.
Check to be sure the oven supports above the
Warming Drawer
do not obstruct the required interior depth and
height. The middle rail separating the openings
may need to be larger than the
2" (5.1 cm) minimum shown. Always refer to the
individual installation instructions packed with
each product for specific requirements.
Warming Drawer Combined with
Advantium or Microwave Oven
and Single Oven:
install a separate 120V, 60Hz, properly ground-
ed receptacle. See installation
instructions packed with each product
for specific requirements.

Publicidad

loading

Este manual también es adecuado para:

Zet2 serie