GE ZET1 Serie Instrucciones De Instalación página 7

Cabinetry
A4 | Single Oven Cutout
for Installation Over
a Monogram Warming
Dra
Drawer Requirement
2" (5.1 cm) Min.
} Na
1" (2.5 cm) Min. Above Toekick or
Adjust to Oven Installation Height
Per Warm-
ing Drawer _
Requirement ~ -
NOTE: Additional clearances between cutouts may
be required. Check to be sure the oven supports
above the Warming Drawer location do not ob-
struct the required interior depth and height.
A5 | Double Oven Cutout
|) Anti-Tip Block Against
Rear Wall Per Warming
NOTE: Install the
oven only with spe-
cific models listed on
the label located on
top of the oven.
for Installation Over
a Monogram Warming
Drawer
| | | Anti-Tip Block
| Against Rear
| Wall Per Warm-
| | ing Drawer
Requirement
2' (5.1 cm)
H Min.
Per Warm-
ing Drawer Le
Requirement ~
1" (2.5 cm) Min. Above Toekick
e When installing a Monogram Warming Drawer
below a single or double oven, a separate 120V,
60 Hz, properly grounded receptacle must be
installed. Refer to
installation instructions packed with the
Warming Drawer for specific installation
requirements.
Frameless Cabinets
Whenever possible, order 30" (76.2 cm) frameless
cabinet with the cutout sided to fit
the oven. If using stock cabinets, additional fin-
ished filler pieces may be required to
cover the opening.
e Astock frameless cabinet cutout width
may be up to 28 3/4" (73 cm). If necessary, add
1/2" (1.3 cm) cleats to the sides, flush with the
front edge of the side panels to accept mount-
ing screws.
46} Cutout for Frameless Cabinets
Install 1/2"
(1.3 cm}
Cleats to
Hold Oven
Cabinet Depth
23 1/2" (59.7 cm)
Min. From Inside
Back to Front of
Mounting
pe] 28 1/2" (72.4em) L ]
Screws <<]
le—.. Min, —
28 5/8" (72.7 cm}
27 5/16" (69.2 cm)
~ 3/4" (1.9 cm) Min.
Thick Bottom Shelf
Cut Back Flush with
Front of
Side Panel