Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
MPORTANT SAFETY INSTRUCTIONS
For Your Safety
e Be sure your oven is installed properly by
a qualified installer or service technician.
e Make sure the cabinets and wall coverings
around the oven can withstand the
temperatures (up to 200°F [93.3°C]) generated
by the oven.
e Be sure the oven is securely installed in a
cabinet that is firmly attached to the house
structure. Weight on the oven door could cause
the oven to tip and result in injury. Never allow
anyone to climb, sit, stand or hang on the oven
door.
A
WARNING: The electrical power
to the oven supply line must be shut
off while line connections are being made.
Failure to do so could result in serious
injury or death.
Electrical
Requirements
This appliance must be supplied with the
proper voltage and frequency and connected
to an individual, properly grounded branch
circuit, protected by a circuit breaker or fuse. See
the rating plate located on the oven frame to
determine the rating of the product. Use
the chart below to determine the minimum
recommended dedicated circuit protection.
Recommended
KW Rating
KW Rating
Circuit Size
240V
208V
(Dedicated)
$4.8 KW
$4.1 KW
20 Amp
49 KW-7.2 KW
4.3 KW-6.2 KW
30 Amp
7.3 KW-9.6 KW
6.3 KW-8.3 KW
40 Amp
9.7 KW-12.0 KW
8.4 KW-10.4 KW
50 Amp
Electrical
Requirements (cont.)
Rating plate is located on the oven side trim, side
front frame or lower front frame.
Rating Plate
Location
asuesoaageassaquaaas
LY
We recommend you have the electrical
wiring and hookup of your oven connected by
a qualified electrician. After installation, have
the electrician show you where your main oven
disconnect is located.
Check with your local utilities for electrical codes
which apply in your area. Failure to wire your oven
according to governing codes could result ina
hazardous condition. If there are no local codes,
your oven must be wired and fused to meet the
requirements of the National Electrical Code, ANSI/
NFPA No. 70-Latest Edition. You can get a copy by
writing:
National Fire Protection Association
Batterymarch Park
Quincy, MA
02269
Effective January 1, 1996, the National Electrical
Code requires that new, but not existing,
construction utilize a four-conductor connection to
an electric oven. When installing an electric oven
in new construction, a mobile home, recreational
vehicle or an area where local codes prohibit
grounding through the neutral conductor, follow
the instructions in
the section on NEW CONSTRUCTION AND FOUR-
CONDUCTOR BRANCH CIRCUIT CONNECTION.
You must use a three-wire, single-phase A.C.
208Y/120 Volt or 240/120 Volt, 60 hertz electrical
system. If you connect to aluminum wiring,
properly installed connectors approved for use
with aluminum wiring must be used.
Publicidad
