Publicidad
Idiomas disponibles
Idiomas disponibles
EN
1. The operator must be in place when testing the
operator presence control switch.
2. Press the push button switch with the key fob
inserted.
3. Push the steering control levers to the neutral
position.
4. Pull the PTO switch ON to engage the motor.
5. Slowly leave the place. The deck blade system
should stop.
6. If the deck blade system fails to stop when the
operator is not in place and if the cause cannot
be determined, contact your greenworkscommercial
dealer immediately.
9.4
ROPS (ROLL OVER PROTECTIVE
STRUCTURE)
A ROPS may minimize the chance of injury or death
from rollover. The two-post ROPS can be pivoted down
by removing the clevis pins (1) after pulling out on the
R-pins (2) so that the machine can operate under low-
hanging tree limbs or other obstructions. Do not wear
the seat belt when the ROPS is in the lowered position.
Use the ROPS in the "folded" position only when it is
absolutely necessary.
1
Install the roll over protection structure (ROPS)
1. Insert the block (3) from the front hole on the
bracket outward.
2. Slide ROPS tube into the bracket. Align the
assembly holes on ROPS tube with the holes on
bracket.
3. Insert bolts through the washers and the assembly
holes, pre-tighten the nuts manually. (For easy
installation, operate on left and right sides at the
same time.)
4. Insert the celvis pins through the springs and the
assembly holes. Insert the R-pins into the holes on
the celvis pins to fix.
5. Use an 18 mm wrench to tighten the nuts. (70ft-lbs
(95Nm))
2
English
Do not operate the mower with the ROPS folded
(lowered position) -- a standard operating mode. A
folded ROPS does not provide rollover protection.
Always wear your seat belt unless the ROPS is folded
down. In this case, the seat belt should never be worn.
To minimize chance of injury or death from rollover:
•
Keep ROPS in the raised and locked position and
use the seat belt.
•
Lower the ROPS only when absolutely necessary.
•
Drive slowly and carefully. Raise the ROPS as
soon as clearance permits. Read and follow slope
operation instructions and warnings.
•
Always fasten seat belt during operation of
the machine (mower equipped with ROPS in
"raised/up" position).
•
Inspect the area to be mowed for proper overhead
clearance (tree limbs, guy wires, doorways, etc.)
Do not contact any overhead object with the
ROPS.
Always pull from the tractor hitch. Do not attach chains
or ropes to the ROPS for pulling purposes, as the
machine can tip backwards.
9.5
ANTI-SCALP WHEELS
Anti-scalp wheel kits are standard on
greenworkscommercial units. These anti-scalp wheels
(1) are designed to minimize scalping when mowing on
16
3
WARNING
WARNING
WARNING
WARNING
Publicidad
