Troy-Bilt 020210 Manual Del Propietário página 12

Section 4: Operation
6. AppHy high pressure spray to small area and check
surface for damage. If no damage is found_ you can
assume it is okay to continue cleaning.
7. Start at top of area to be rinsed_ working down with
same overlapping strokes as you used for cleaning.
Cleaning Detergent Siphoning Tube
ff you used the detergent siphoning tube, you must flush it
with clean water before stopping the engine.
I. Place chemical injection siphon/filter in a bucket full of
dean water.
2. Attach bhck cleaning detergent nozzle.
3. Flush for I-2 minutes.
4. Shut off engine.
IMPORTANT: Simply shutting
OFF
engine will not
release pressure in the system. When the engine has
shut down, squeeze the
trigger
on the spray
gun
to
relieve the pressure in the hose.
Automatic Coo[ Down System
(Thermal Relief)
If you run the engine on your pressure washer for
3:5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures
above 125°EThe system engages to cool the pump by
discharging the warm water onto the ground.