Troy-Bilt 020210 Manual Del Propietário página 8

Section 3: Assembly
2_
SimiHarHy, attach other end of high pressure hose to
high pressure oudet on pump (Figure 5). PuHH down on
coHHar o f quick connect_ sHideonto pump and Hergo of
coHhr, PuHH on hose to be sure of tight connection.
pressure hose here
3_
Before connecting garden hose to water inHet_ inspect
inHetscreen (Figure 6).
CHeanscreen if it contains debris, repHace if damaged.
DO NOT RUN PP, ESSUF{EWASHERIF SCP, E EN IS
DAHAGED.
r_ Z_._/<_/__ NOT use if
'-_ _amaged, dean if
dirty.
4, Run water through garden hose for 30 seconds to
dean out any debris,Turn off water.
IMPORTANT: DO NOT siphon standing water for the
water supply. Use ONLY coHd water (Hessthan H OO°F).
5, Connect garden hose (not to exceed 50 feet in Hength)
to water inHet.Tighten by hand (Figure 6).
Damageto equipment resulting from failure to follow this
instruction will void warranty,
6, Turn ON water and squeeze trigger on spray gun to
purge pump system of air and impurities.
WANNING
Always wear eye protection when using this equipment or in
vicinity of where equipment is in use.
Before starting the pressure washer, be sure you are wearing
adequate eye protection,
Checklist Before Startin E gine
Review the unit's assembHy to confirm you have performed
aHH of the following:
H. Hake sure handHe is in pHace and secure.
2, Check that oiH has been added to proper HeveH in
engine crankcase.
3, Add proper fueH to fueHtank.
4, Check for properHy attached hose connections.
5, Check to make sure there are no kinks_ cuts_ or
damage to high pressure hose.
6, Provide a proper water suppHy (not to exceed HOO°F)
at an adequate flow.
7, Be sure to read "Safety P, u Hes"and "HowTo Use
Pressure VVasher" before using pressure washer.
O