Troy-Bilt 020210 Manual Del Propietário página 16

Storage
PREPAPJNG THE fJNmT
FOP, STORAGE
Water shouHd not remain in the unit for Hong periods of
time. Sediments or minerals can deposit on pump parts and
"freeze" pump action. If you do not pHanto use the
pressure washer for more than 30 days, follow this
procedure:
H. Rush detergentsiphoning tube by pHadng fiHter intoa
paiHof dean water while running pressure washer in
low pressure mode. Flush for one to two minutes.
2. Shut off engine and let it cool, then remove high
pressure and garden hoses. Disconnect spark plug wire
from spar[< pHug.
3. Empty pump of Hiquids by puHHing engine recoiH handle
about 6 times.This should remove most liquid in pump.
4. Use PumpSaver to prevent corrosion buiHd up and
freezing of pump.
5. Store unit in a dean, dry area.
Protecting the
Pump
To protect the pump from damage caused by mineral
deposits or freezing, use PumpSaver to treat pump.This
prevents freeze damage and Hubricates pistons and seaHs.
NOTE: PumpSaver
is available as an optionaH accessory.
It
is not incHuded with the pressure washer. Contact the
nearest authorized service center to purchase PumpSaver.
To use PumpSaver, make sure the pressure washer is
turned off and disconnected from suppHy water. Read and
follow aHH instructions and warnings given on the PumpSaver
container.
• Failure to do so will permanently damage your pump and
render >,our unit inoperable,
• Freeze damage is not covered under warrant>;
CAUTION
Always wear eye protection when using PumpSaver.
• Protect surfaces from dripping PumpSaven
NOTE: if PumpSaver
is not avaiHabHe,draw RV antifreeze
(nonoaHcohoH) into the pump by pouring the soHution into a
3°foot section of garden hose connected to inHet adapter
and puHHingrecoiH handHe twice.
STOPJNG THE ENGINE
See the engine owner's manual for instructions on how to
properHy prepare the engine for storage.