Publicidad
Idiomas disponibles
Idiomas disponibles
6. Technical data
Mains voltage
Power consumption
Stroke rate
Lifting movement
Base
Tilting table
Table size
Saw blade length
approx.
(between both pins)
Swing
Cutting height max.
at 90°
Cutting height max.
at 45°
Protection category
Suction port ø
Weight
Subject to technical changes!
*Operating mode S1 (continuous operation)
The machine can be operated continuously with the
specified power.
**Operating mode S2 (short-term operation)
The machine may be operated for a short period of time
with the specified power.
Device emissions values
Noise
The noise values have been determined in accordance
with EN 62841-1:2015.
Wear hearing protection.
Excessive noise can result in a loss of hearing.
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
WA
Uncertainty K
WA
32 | GB
230-240 V~/50 Hz
70 watts (S1*)
90 Watt (S2 15 min**)
550-1500 rpm
18 mm
650 x 255 x 340 mm
0° to 45° to the left
254 x 407 mm
12.7 mm
405 mm
50 mm
20 mm
IP20
34.5 mm
8 kg
80.4 dB
3 dB
93.4 dB
3 dB
www.scheppach.com
The stipulated values are emission values and so do
not necessarily represent safe work station values. Al-
though there is a correlation between emission levels
and exposure levels, it is not possible to reliably deter-
mine whether additional precautionary measures will
be required or not based on this. Factors that could
influence the emissions level present at any given time
at the work station include the duration of exposure,
the nature of the working area, other noise sources
etc. e.g. the number of machines and neighbouring
processes.
The permitted workstation values can also vary from
country to country. However, this information should
enable the operator to better evaluate the hazards and
risks.
Limit the noise level to a minimum!
• Only use faultless devices.
• Maintain and clean the device at regular intervals.
• Adapt your working methods to the device.
• Do not overload the device.
• Have the device checked if necessary.
• Switch the device off if it is not in use.
Suitable saw blades
All industry-standard saw blades with a minimum
length of 133 mm with and without a pin may be used.
7.
Before commissioning
7.1 Unpacking
• Open the packaging and carefully remove the prod-
uct.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the product and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
• If possible, keep the packaging until the expiry of the
warranty period.
• Familiarise yourself with the product by means of the
operating manual before using for the first time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Spare parts
can be obtained from your specialist dealer.
• When ordering please provide our article number as
well as type and year of manufacture for the product.
Publicidad
