Publicidad
Idiomas disponibles
Idiomas disponibles
Damaged electrical connection cable
The insulation on electrical connection cables is often
damaged.
This may have the following causes:
• Pressure points, where connection cables are
passed through windows or doors
• Kinks where the connection cable has been improp-
erly fastened or routed
• Places where the connection cables have been cut
due to being driven over
• Insulation damage due to being ripped out of the wall
outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Ensure that the connection cables are dis-
connected from electrical power when checking for
damage.
Electrical connection cables must comply with the ap-
plicable VDE and DIN provisions.
Only use connection cables with the marking H 05 VV-
F.
The printing of the type designation on the connection
cable is mandatory.
AC motor
• The mains voltage must be 230-240 V~.
• Extension cables must have a minimum cross sec-
tion of 1.5 mm² (≤ 25m).
• Extension cables must have a minimum cross sec-
tion of 2.5 mm² (> 25m).
Connections and repair work on the electrical equip-
ment may only be carried out by electricians.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Data of machine type plate
Connection type Y
If the mains connection cable for the product is dam-
aged then it must be replaced by the manufacturer
or their customer services personnel or by a similarly
qualified person, in order to avoid hazards.
36 | GB
11. Transport
• Transport the electric tool by lifting it on the recesses
provided for this on the frame and the engine cover.
• Never use the protective devices for handling or
transport.
• Make sure that the exposed part of the saw blade
is covered during transport, e.g. by the protective
device.
12. Cleaning, maintenance and
ordering spare parts
m Attention!
Pull out the mains plug before carrying out any
cleaning or maintenance work.
12.1 Cleaning
Keep protective devices, air vents and the engine
housing as free of dust and dirt as possible. We rec-
ommend cleaning the device directly after every use.
12.1.1 Exterior cleaning
• Keep protective devices, air vents and the engine
housing as free of dust and dirt as possible. Rub the
product clean with a clean cloth or blow it off with
compressed air at low pressure.
• We recommend that you clean the product directly
after every use.
• Clean the product at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic
parts of the product. Make sure that no water can
penetrate the interior of the product. Water penetra-
tion increases the risk of an electric shock.
12.1.2 Interior cleaning (fig. 15)
1.
Remove the screw (33).
2.
Loosen the screw (32).
3.
Remove the cover (7).
4.
Blow out the device interior with low-pressure
compressed air.
5.
Attach the cover again (7).
6.
Fasten the screw (32).
7.
Insert the screw (33) again and tighten it.
12.2 Maintenance
After any repair or maintenance work, make sure that
all safety-related parts are in place and in perfect con-
dition. All parts which may cause injury must be kept
where they are inaccessible to children or others.
www.scheppach.com
Publicidad
