Publicidad
Idiomas disponibles
Idiomas disponibles
Do not use air outlet tubes of different sizes or
materials, as they may cause faults.
HOW TO USE
USE:
- Unwind the cable completely before plugging in.
- Plug the appliance into the mains.
- Orient the appliance to direct the air flow to the
desired direction.
- Switch the appliance on by pressing the On /
Off button (A).
- Select the desired mode (D).
- Select desired speed (E).
TIMER FUNCTION:
SETTING THE TIMER ON:
- When the air conditioner is off, press the "F"
button and select the desired power-on time
through the temperature and time adjustment
buttons.
- The on time can be set up to 24 hours.
- The programmed time or remaining time will
appear in the display (G).
SETTING THE TIMER OFF:
- When the air conditioner is on, press the
"F" button and select the desired sleep time
through the temperature and time adjustment
buttons.
- The shut-off time can be set up to 24 hours.
- The programmed time or remaining time will
appear in the display (G).
COLD MODE:
- Press mode (D) to select cold mode, the cold
mode indicator will light up (e).
- Press + or - to set the temperature in a range of
16 ~ 31 ° C (61 ~ 88 ° F).
- Pressing + or - once, the temperature will
increase or decrease gradually.
- Press (E) to select high or low fan speed.
HEATING OPERATION *
- Press the "D" button till the "h" icon appears.
- Press the "TEMP+"or" TEMP-" button to select a
desired room temperature (16 ºC - 31 ºC)
- Press the "E" button to select wind speed.
(*) Only available in AC2600RVKT model
FAN MODE:
- Press mode (D) to select the fan mode and the
fan indicator will light up. Power (g) power to
increase or decrease power speed.
DEHUMIDIFIER MODE:
- Press (D) to select the mode
- Dehumidification mode indicator, and the dehu-
midification mode indicator will light up (f).
COMPRESSOR PROTECTION:
- Three minutes after pressing on / restarting, the
compressor will start to operate.
PROTECTION OF THE WATER TANK:
- When the water level in the lower water plate is
below the warning level, the appliance will notify
you automatically.
- Please pour the water in the machine accord-
ing to the instructions in the chapter "water
drainage".
WATER DRAINAGE:
- When the inside of the water tank is full, the
indicator will light up on the display.
- The device enters the standby mode.
- Remove the plug to remove the water, turn
the machine off and on again, the machine will
operate normally.
- This model has a self-evaporating function, in
the cold mode, please do not make continuous
drains to get a greater effect of cold.
ONCE THE APPLIANCE HAS BEEN USED:
- Stop the appliance by pressing button (A) on/off
- Unplug the appliance from the mains.
- Unplug the appliance from the mains and allow
it to cool down before starting any cleaning
operation.
- Clean the electrical assembly and the mains
plug with a damp cloth and dry them after-
wards. NEVER SUBMIT THEM IN WATER OR
ANY OTHER LIQUID.
CLEANING
- Wipe the appliance with a damp cloth impreg-
nated with a few drops of detergent. Do not use
solvents or products with an acidic or basic pH
factor such as bleach or abrasive products to
clean the apparatus.
- Do not immerse the connector in water or other
liquid or place it under the tap. If the appliance
is not maintained in good condition
- Cleaning, its surface can be degraded and inex-
orably affect the life of the appliance and lead to
a dangerous situation.
Publicidad
