Xylem rule iD20 Manual De Instrucciones página 2

High Speed lnflator/Deflator Model iD20
Features
• Rapid inflation and deflation of all inflatables.
• lnflates a four man dinghy in 1 to 2 minutes.
• Deflates, removing every last ounce of air for easy storage.
• Adjustable nozzles for all inflatables and valve types.
• Light weight and easy to use.
• Easier and faster than manual pumps.
• Temperature sensitive air release valve protects from overheating
and over inflating
• Robust long life construction.
• 10ft. (3m) cable length with battery clips
Operating Instructions
If these simple instructions are followed, your High Speed Inflator
/ Deflator will take the hassle out of inflating and deflating your
dinghy for many years to come.
1. Make sure the correct adaptor is selected to suit your valve (see
diagrams showing typical valve assemblies). Failure to use
the correct adaptor will reduce performance and create back
pressure which causes unwanted heat.
2. Insert adaptor into inflate / deflate port of the High Speed
Inflator.
3. Ensure your battery is in good condition and has a suficient
capacity of 45 AH minimum.
4. Uncoil cable, connect the red (+) battery clip to the positive
terminal and the black (-) battery clip to the negative terminal.
5. Fully engage the adaptor into the dinghy valve and completely
depress the switch.
Safety
Store away from excessive heat and direct sunlight to avoid
external damage.
If the pump fails to perform, check for blockages, air leaks and
correct electrical and adaptor connections.
Specifications
Model
iD20
Cable length 10ft. (3m)
Airflow Pressure
20 ft/min³ 2.6 psi/min
550 lpm 0.18 bar/min
Unwrap cables fully before use.
Do NOT secure in 'ON' position - hand operation only.
Do NOT immerse in water.
If the Inflator is connected to a circuit using connections other than
the battery clips supplied, the connecting fuses should be rated at
25 amps at 12 volts DC. Cigar lighter sockets are NOT suitable.
Do not try to over-inflate the dinghy. The High Speed Inflator
will give between 2.6 and 3.0 PSI (0.18 and 0.21 bar), which is
suitable in most instances. If extra pressure is required, top up
with a manual pump.
When maximum inflation / deflation is reached you will note a
change of tone. If the unit is left running after the tone change no
more pressure will be achieved and the air retained in the pump
chamber will heat rapidly. The temperature sensitive air release-
valve will open, releasing the hot air and protecting the unit from
overheating. However, it will not protect the unit indefinitely and
the unit should be switched off immediately the change of tone
is heard and the release valve starts to vent air. On cooling the air
release valve will reset.
The inflator should not be placed bottom down on a surface when
operating as the air release valve will not function.
The lead can be extended to 20 ft (6 m) without signiicantly
affecting performance. The minimal cross sectional area of the
extending cable should be 10 AWG copper wire (2.5mm²).
For longer extensions the cable should be 8 AWG copper wire
(4.0mm²) minimum.
WARNING: When powering this product from a
car or a boat battery do not switch 'on' and run the
engine. The unit is designed to operate at 12 to 12.7
volts. If the engine is switched on the voltage could
rise to 14 -15 volts, which will seriously damage the
Inflator and the warranty will be disclaimed. The
leads could also entangle in the fan belt and cause
personal and property damage.
Amps
25 max.
Fitted with battery clips
2
Volts Weight
12 1.6lbs
750grms